• Recent Articles

  • Recent Article Comments Widget

  • Hottest Threads

    Michael Arruda

    Home Depot return policy change without notification

    Thread Starter: Michael Arruda

    Hello all, I had some small items left over from various things I've done around the house recently and decided to gather them up to take back to Home Depot. These items were purchased at various times over the past couple weeks and I of course misplaced my receipts. Meaning they got washed,...

    Last Post By: Jim Becker Yesterday, 8:47 PM Go to last post
    Paul F Franklin

    New Lee Valley Web Site

    Thread Starter: Paul F Franklin

    Seems the roll out of the new site is not going completely smoothly. Have been trying to place an order all morning and the site just spins when I try to checkout. Tried a few different browsers too. Guess I may have to call :eek: New site design seems nice and clean though but it will take...

    Last Post By: Rob Luter Yesterday, 12:59 PM Go to last post
    Tim M Tuttle

    Jointer Safety

    Thread Starter: Tim M Tuttle

    I've been milling up a lot of white oak the past two nights. While I was using my jointer I started to ponder safety. For something like the table saw there are a lot of common safety procedures/dos/donts. A lot more than a jointer which makes sense as there are a lot more variables with the...

    Last Post By: Zachary Hoyt Yesterday, 12:53 PM Go to last post
    Bert Kemp

    Getting photos off old hard drive

    Thread Starter: Bert Kemp

    OK so I got a new refurbed pc , I took the hard drive out of the old pc and scrapped the case. I'd like to get the pictures off that drive but have no idea how to go about it. I'm just a little tech savy so any instuctions would have to be very detailed. Like what hardware or software would i need...

    Last Post By: Doug Garson Yesterday, 11:19 PM Go to last post
    Andrew Pitonyak

    Felt on the bottom of a drawer

    Thread Starter: Andrew Pitonyak

    I have some drawers that are roughly 16" deep and 18" wide. The drawers are not deep, from 3/4" to 3". Some of the drawers will contain things such as pocket knives. The drawers do not have partitions. The drawer bottoms are slick so I was thinking about putting felt down on the...

    Last Post By: roger wiegand Yesterday, 2:15 PM Go to last post
    Thomas Crawford

    restoring a powermatic 15HH

    Thread Starter: Thomas Crawford

    So this thing followed me home finally last week. Its a bit of a mess but I'm hoping I can get it all cleaned up.

    Last Post By: Matt Day Yesterday, 12:55 PM Go to last post
  • Bert McMahan

    There is no available content written by Bert McMahan