• Bill Dufour

    There is no available content written by Bill Dufour
  • Recent Polls

    Which tablesaw? (Votes: 30)

    1. Sawstop PCS31230-PFA30 (Votes: 12)

    2. Minimax SC 2C (Votes: 6)

    3. Hammer K3 Winner (Votes: 12)

  • Recent Forum Posts

    Steve Mathews

    I need some good flashlights?

    Based on comments above I may change my mind on the rechargeable batteries. If they are less prone to leakage then I'm all in. I may also change my

    Steve Mathews Today, 4:58 PM Go to last post
    Thomas Wilson80

    OneWay 1224 Lathe

    Full disclosure, I’ve never turned on a Oneway lathe and while I’ve heard good things about them, they are way overpriced IMHO. I think the

    Thomas Wilson80 Today, 4:58 PM Go to last post
    Jon McElwain

    OneWay 1224 Lathe

    I've got a Oneway 2436. Top notch quality and I expect that the 1224 will be the same. For a "starter" lathe, I think the Oneway might be

    Jon McElwain Today, 4:56 PM Go to last post
    Andrew Seemann

    Non Sliding 12" Miter Saw

    If is is specific to the big box there may be a difference, but if it is the same model, it should be the same no matter where you get it. It looks like

    Andrew Seemann Today, 4:53 PM Go to last post
    Tristan Wilson

    Cutting rounds by hand

    Hello all,
    I'm a total newb but some amazing wood just fell into my lap and I want to make good use of it. So what happened is my friends neighbor

    Tristan Wilson Today, 4:53 PM Go to last post
  • Recent Blog Posts