• Sections

  • Recent Articles

  • Recent Article Comments Widget

  • Hottest Threads

    Tom M King

    Bad job coming

    Thread Starter: Tom M King

    I have these two raised panel garage doors to refinish on a lake rental house. Just testing a couple of panels, it won't be too bad sanding down to bare wood, but someone had put another coat of marine varnish on the bottom two sections, so those are going to get some work with a heat gun before...

    Last Post By: John TenEyck Today, 7:34 PM Go to last post
    John Kananis

    Harvey Slider on Unisaw?

    Thread Starter: John Kananis

    All these slider threads got me thinking. Does anyone here have the Harvey compass st-1500 attached to their unisaw? Can you speak on the quality, ease of attachment, capabilities and shortcomings? Thank you in advance!

    Last Post By: Michael Zerance Today, 7:46 PM Go to last post
    Edward Weber

    Swiss Army ... tool

    Thread Starter: Edward Weber

    https://www.cnn.com/2024/05/07/business/swiss-army-knife-blade-scli-intl/index.html While I understand the decision, I can't help think that, I carry a pocket knife, with a blade only and use it for so many tasks. I think I would be fumbling through the selection of tools trying to find a...

    Last Post By: Edward Weber Today, 7:25 PM Go to last post
    Tom Yaegle

    SCM T130 bearing change

    Thread Starter: Tom Yaegle

    Has any one here done one? Looking for suggestions, thanks.

    Last Post By: Tom Yaegle Today, 6:11 PM Go to last post
    John Kananis

    Spindle gouge bevel angle?

    Thread Starter: John Kananis

    I have a 1/2" sorby detail gouge that I have ground at 40° (also removed the heel) and it works ok now that I moved away from the jigs and started sharpening by hand... but it's still just an ok tool. I now have a d-way detail spindle gouge (1/2") on the way and was thinking about trying a 25°...

    Last Post By: Don Frank Today, 8:57 AM Go to last post
    Brent Ring

    Powermatic Model 80 20" Bandsaw - Yes or No?

    Thread Starter: Brent Ring

    All, I have been in the market for a bigger bandsaw. Starting to build some rocking chairs a la Hal Taylor, and my PM 141 does not have enough clearance to make a few of the cuts needed. A Powermatic 80 20" had come up in my area, for a little under $1k. Owner states it runs smooth, cuts well....

    Last Post By: Mickey Plunkett Today, 11:47 AM Go to last post

  • Chance Raser

    There is no available content written by Chance Raser