How to bend wood like this - Outdoor furniture project

Looking for a new project to do. I've been spending a few months upgrading the workshop / fixing minor annoyances, and really need to actually build something. I ran across this in a magazine ad. The furniture is supposedly solid teak, though I don't think that will be in the cards for...

Is there a small, accurate table saw?

I need to downsize my hobby woodworking shop a bit, and would like to have a table saw that is smaller than a cabinet saw with the extension table. Is there a smaller table saw that would still be as accurate as a cabinet saw? Most of the smaller saws are jobsite saws, and they don't seem to have a...

cope and stick micro shaker?

has anyone done a cope and stick micro/skinny shaker setup, or is the consensus that it's always a miter wrap? i talked to Great Lakes a while back, and they hadn't seen it (or at least my rep hadn't), curious what others have done. i would much, much rather make them on the shaper than at the...

AC electrical puzzlement

This morning I plugged in a small electric heater for the bathroom. No sign of life, figured it was either the heater or outlet. I turned off the circuit breaker (after I found it, panel is poorly labeled), removed the outlet and began poking around with a meter. Black to white was 0 volts, I was...

Drill w/guide or router?

Here's one I've been going over for the last 6 months. We have sliding pocket doors that separate our dining room and our family room. There are two of them 30 inches wide and they meet in the middle to form one 60 inch opening when open and a solid "wall" when closed. When they are open,...

Looking for feedback before I buy an Avid CNC

Good day all. I appreciate the time to read and give feedback. I think this is the right machine and price, but want feedback. The time has come. I need a CNC to stay competitive and I also just want to create in new ways. I have “non-buyers remorse” for stopping bidding on a beautiful 5x10...

Fuji MiniMite 4 Gold

Thank you, sold

Shop Project: Finally flattening my main bench top

The cleanup went surprisingly easy...I created the "world's largest shop vac" and sucked it all up. The hose wouldn't reach on it's own

Box for Cremation Ashes

That's how my parent's cremains are currently housed a few feet from where I am typing this. (still need to arrange for the memorial service and interment

New Workshop Questions

No question, go for the thicker steel. Stiffer and will handle the load better. If I had chosen a steel building instead of the post frame I went with,

New Laguna DriftMaster LXIII

I did mention to use your stock fence "or one you like better" in my post. If the Driftmaster was the one you liked better, that's fine with

SC Pig-Picking