• Recent Articles

  • Recent Article Comments Widget

  • Hottest Threads

    Patrick Walsh

    Vintage Martin T75 restoration

    Thread Starter: Patrick Walsh

    So I have a opportunity to purchase the above machine for a fair deal from my employer. I am aware of the phenolic guides being pop riveted I the the sliding table along with not availible for replacement. So my question is as follows to those in the know with regard to the phenolic ways....

    Last Post By: Patrick Walsh Today, 9:39 PM Go to last post
    Thomas Wilson

    Rules of Thumb for Workshop Size

    Thread Starter: Thomas Wilson

    Hi all, I am a new member and this is my first question. I am about to build a new garage/workshop to house my tools that are currently scattered in several locations because I have outgrown my 18x26 basement shop. I have worked on general arrangements of a functional shop but I am coming up...

    Last Post By: Thomas Wilson Today, 11:15 AM Go to last post
    Thomas Crawford

    restoring a powermatic 15HH

    Thread Starter: Thomas Crawford

    So this thing followed me home finally last week. Its a bit of a mess but I'm hoping I can get it all cleaned up.

    Last Post By: Matt Day Today, 5:02 PM Go to last post
    Ollie McDottie

    Why a 12" jointer?

    Thread Starter: Ollie McDottie

    I'm in the market for a new jointer. So obviously, I've spent an inordinate amount of time reading up on the options/opinions. Currently I'm waffling between an 8" Powermatic HH parallelogram and Laguna 12" HH parallelogram. Blog after blog, forum upon forum, folks seem to all say bigger is better....

    Last Post By: Rod Sheridan Today, 1:13 PM Go to last post
    Tim Derr

    Felder Group USA Support

    Thread Starter: Tim Derr

    Let's talk. Good Day Creek! I wanted to reach out to you all and let you know that I will be taking over on the forums for Felder Group. My name is Tim Derr and if you ever need anything,...

    Last Post By: Dan Friedrichs Today, 7:47 PM Go to last post
    ken hatch

    Time To Eat Crow

    Thread Starter: ken hatch

    For years I've had a thing about tail vises, end vises, wagon vises, for that matter anything that hangs off or works from the right end of my right handed bench. I've thought they were not worth the time or money to install. That there were better ways to do the same job from a...

    Last Post By: ken hatch Today, 3:25 PM Go to last post
  • Mike Cutler

    There is no available content written by Mike Cutler