• Recent Articles

  • Recent Article Comments Widget

  • Hottest Threads

    Patrick Walsh

    Vintage Martin T75 restoration

    Thread Starter: Patrick Walsh

    So I have a opportunity to purchase the above machine for a fair deal from my employer. I am aware of the phenolic guides being pop riveted I the the sliding table along with not availible for replacement. So my question is as follows to those in the know with regard to the phenolic ways....

    Last Post By: Patrick Walsh Today, 6:14 PM Go to last post
    John K Jordan

    Hawk and chicken

    Thread Starter: John K Jordan

    One of my favorite chickens was attacked by a red-tailed hawk today. I heard the commotion and ran up the hill and chased the hawk away. At first examination it looked like one eye was missing but I think it's OK under an abraded eyelid. There were two places on the chest where skin was...

    Last Post By: Tom M King Today, 7:31 PM Go to last post
    Tom Bender

    Handplane vs Lunchbox

    Thread Starter: Tom Bender

    A hand plane makes a better surface than a planer because it makes one long straight cut vs many short curved cuts. But a planer impacts the wood. Does blade speed also make a difference? This may sound like a power tool question but I've brought it to the Neandercult because here we think a...

    Last Post By: steven c newman Today, 3:28 PM Go to last post
    Dennis Peacock

    Shapeoko - XXL - Anybody running one?

    Thread Starter: Dennis Peacock

    Well, I've seriously looked at my finances and it has reflected that I am not going to be able to pay cash for a Stinger II or even a Stinger I CNC setup. So, I'm now looking at the Shapeoko 3 XXL to allow me to get experience with CNC and enable me to do a few things that I could surely use in my...

    Last Post By: John Lifer Today, 4:35 PM Go to last post
    johnny means

    Lubrication for wood drilling?

    Thread Starter: johnny means

    So this needs to happen a couple of hundred times. 3/4" bradpoint into endgrain 6" deep. Obviously, friction is my enemy. What options do I have for lubrication/cooling that won't screw with my finishing?

    Last Post By: johnny means Today, 12:09 PM Go to last post
    Tom Bender

    Bondo

    Thread Starter: Tom Bender

    Auto Body Filler has it's uses in my shop. When a mortise is good on the surface but oversized in the center, this stuff is easily formed to provide a more sturdy fit, unlike most epoxy which tends to run out. Also, it sands easily and it's inexpensive. It can also be used to fill voids under...

    Last Post By: Allan Speers Yesterday, 7:54 PM Go to last post
  • Edward Weingarden

    There is no available content written by Edward Weingarden