• Barry McFadden

    There is no available content written by Barry McFadden
  • Recent Polls

    Which fence: (Votes: 12)

    1. Delta Biesemeyer 78919B Type 2 (Votes: 2)

    2. SawStop TGP2-FA (Votes: 6)

    3. Something else (Votes: 4)

  • Recent Forum Posts

    Stewart Lang

    buying a jointer

    Unless you really need the space, a floor-standing jointer will be much better built than a benchtop one, in general. Jointers are somewhat finicky machines

    Stewart Lang Today, 1:13 PM Go to last post
    Jay Kepley

    Piping new-to-me DC

    I'm in the process of converting a 2 hp Jet dust collector to a two stage. I'll offer some comments that may or may not be useful to you. First, Oneida

    Jay Kepley Today, 1:13 PM Go to last post
    Roger Chandler

    Grizzly lathes

    The shortened length means they took away the swing-away tailstock on the Shop Fox version...otherwise, it is the same as the G0800.

    Roger Chandler Today, 1:07 PM Go to last post
    Jim Koepke

    Critique my dovetails? First attempt at a double

    It was done using a few chisels, here is a close up of one in use:

    That is most likely my 1" Witherby being used.

    Jim Koepke Today, 1:02 PM Go to last post
    jeff oldham

    buying a jointer

    i am leaning to buy a jointer but there is so many reviews on them its hard to decide,,i was leaning to the benchtop type,,but for not much more you can

    jeff oldham Today, 12:57 PM Go to last post
  • Recent Blog Posts