• Recent Articles

  • Recent Article Comments Widget

  • Hottest Threads

    Dave Anderson NH

    Time for some levity

    Thread Starter: Dave Anderson NH

    With all of the negativity and political stuff going on with the Covid-19 virus it is time to look at the humorous side of things. Feel free to add more, but keep it clean or it will be deleted.

    Last Post By: Dave Anderson NH Today, 12:41 PM Go to last post
    Phil Mueller

    Made in China sentiment

    Thread Starter: Phil Mueller

    As a retail small business owner, selling a number of high quality made in China products, Iím curious of any changes in consumer sentiment. Given the current pandemic, will made in China products be more of a deal breaker, or the same? Obviously, if you avoided made in China in the past, you...

    Last Post By: Doug Dawson Yesterday, 7:01 PM Go to last post
    Kenny Southerland

    Table Saw Not cutting 90* (HELP!)

    Thread Starter: Kenny Southerland

    I am having a problem with my table saw that is about to make me lose my mind (up in here, up in here). I am about to finish my first year of woodworking. I have a 90s model craftsman table saw that I have had for about 9 months. It is the 315.228390, essentially the same thing as...

    Last Post By: Myk Rian Today, 11:57 AM Go to last post
    Dan Gaylin

    Forstner bit problems

    Thread Starter: Dan Gaylin

    So I was doing the rare bit of spindle work (I mostly do bowls) and I was trying to get a 1 3/4” diameter recess for a candle in a cherry candlestick I had turned. I put my 2 MT drill chuck in the tail stock and put a 1 3/4” forstner bit into the chuck. Set my lathe to its lowest speed. Brought...

    Last Post By: John K Jordan Today, 9:14 AM Go to last post
    Derek Cohen

    Marking knives for joinery

    Thread Starter: Derek Cohen

    These are some the knives I have collected over the years and use for laying out joinery. Obviously not all at the same time :) Three popular knives - these ones get a lot of use. From the top down ... Swann-Morton fixed blade, Stanley swivel blade, and a Swann-Morton craft knife which was my...

    Last Post By: mike stenson Today, 10:52 AM Go to last post
    joe webb

    Closet remodeling

    Thread Starter: joe webb

    Hello all, Hope everyone is safe and healthy during this pandemic. I am back for a new project. Now that we can't travel, I have plenty of time for DIY projects, so I will start ripping off all our closets one by one to put shelves and cabinet in them. We have both walk-in and reach-in...

    Last Post By: Matthew Hills Yesterday, 2:55 PM Go to last post
  • Mark Stutz

    There is no available content written by Mark Stutz