• Recent Articles

  • Recent Article Comments Widget

  • Hottest Threads

    Patrick Walsh

    Vintage Martin T75 restoration

    Thread Starter: Patrick Walsh

    So I have a opportunity to purchase the above machine for a fair deal from my employer. I am aware of the phenolic guides being pop riveted I the the sliding table along with not availible for replacement. So my question is as follows to those in the know with regard to the phenolic ways....

    Last Post By: Frank Drackman Today, 5:42 PM Go to last post
    Mike Heidrick

    Pole Barn 40X64X16

    Thread Starter: Mike Heidrick

    Signed a contract yesterday with S&L Builders out of Indiana for a 40X64X16 Pole Barn with a 10X24 porch. Build date August 18, 2014. Plan to install Pex for raidant floor heat. Concrete slab 5" thick. Also doing 1.5" closed cell foam under the pad. Built on Laminated posts in ground. Will...

    Last Post By: Mike Kees Yesterday, 9:09 PM Go to last post
    Patrick Walsh

    1982 Martin T-23

    Thread Starter: Patrick Walsh

    And so it seems it begins again. The T-75 isn’t even technically done and I have a new project. I’m not gonna go all buggy on this one “just yet” if ever. I will 100% go all the way through the machine and make sure it is 100% fully functional to the 9’s. 10’ for me if it was a term. If anything...

    Last Post By: Patrick Walsh Today, 1:12 PM Go to last post
    Ken Fitzgerald

    Shop lighting......

    Thread Starter: Ken Fitzgerald

    Here's an article that answers a lot of shop lighting questions that are so often asked here. http://www.sawmillcreek.org/content.php?146-Lighting-the-Small-Workshop-by-Jack-Lindsey

    Last Post By: Bill Webster Yesterday, 9:51 PM Go to last post
    Andrew Pitonyak

    Help me understand the MSDS for Honing Oil

    Thread Starter: Andrew Pitonyak

    Help me understand the MSDS for Honing Oil. Remember, I have not had Chemistry since high school, in the early 1980's. Norton Sharpening Oil - Highly refined Mineral Oil I was told that Norton Sharpening Oil is not much more than highly refined mineral oil and the MSDS was pretty easy to...

    Last Post By: Mel Fulks Yesterday, 10:13 PM Go to last post
    Travis Conner

    Having tools delivered by freight truck?

    Thread Starter: Travis Conner

    The neighbors have a forklift, but I hate having to ask them since a lot of people do. If I pay the 50 dollar lift gate fee does that mean they're going to just drop it off in front of the shop or can I at least get the guy to roll it just inside the door of the shop? I know a lot of those third...

    Last Post By: Ben Rivel Today, 5:16 PM Go to last post
  • Tom M King

    There is no available content written by Tom M King