Has been restocked.. Bought 10 planks...for $30...had to cut a few of the 10 footers down, to fit into the Trunk of my Chevy Equinox... Eight 1 x 6 x 6' Five 1 x 4 x 6' And he threw in a stack of shorts And a 3/4" x 8" x 39" slab..
Last Post By: steven c newman Today, 9:04 AMAbout a year ago I was reading and found that Vietnam veterans qualified for VA medical benefits. About the same time, I was talking with a neighbor who came over to ask me about hearing aids. I have bimodal hearing; I have a cochlear implant (CI) on one ear and a hearing aid (Ha)on the other ear...
Last Post By: Mike Henderson Yesterday, 11:09 AMDue to health reasons, I can no longer use my shop, I'll be selling everything starting with my Lathe tools and the Powermatic 3520B: Woodcutter coring tool W/laser. $350 Sorby texturing tools - the complete set W/ micro set. $250 Sorby captive ring tool set (3 pc.) $60 Elbow hollowing tool W/...
Last Post By: tom lucas Today, 7:14 AMIn my small shop most things are kept in drawers and anything like packaging is turfed out rather than claiming space. Tools like drills share bits etc with other drills and are easily accessed from drawers. If my router lived in a Systainer the accessories would have to live elsewhere, at least...
Last Post By: Rich Engelhardt Today, 8:40 AMI have a Gitzo tripod that was bought in the late 1970s. The rubber ring for tightening the nut on the telescoping section to raise and lower the camera has finally stretched to the point of uselessness. Years ago when talking to a rep. at Gitzo I was told the part is unavailable and my model...
Last Post By: Jim Koepke Yesterday, 10:37 PMSure - why not? (Votes: 9)
Never. If I needed something, I'd buy or rent it. (Votes: 10)
Maybe. Depends on the person and the tool. (Votes: 52)
6 each 1", 2" and 3" d. x 9" long 120# sleeves. Cost of shipping or pick up in VT.
Kevin Jenness Today, 9:09 AM1st Router table use...needed a jig to slide along the fence..
To run parts past a dovetail bit..
9 "rails", dovetail
Alas, that's not a thing with many subcompacts that utilize blow molded tanks that are complexly shaped and generally live under the seat, draping over
Jim Becker Today, 9:02 AMWhen that's happened with my Kubota BX22 over the years (same HP engine) it's generally been in the fuel system...debris or bad fuel. Clean/change the
Jim Becker Today, 9:00 AMMy little diesel Ford has a hand throttle and a foot throttle. Several times I have run over a stick or sapling that got stuck in the foot throttle linkage
Maurice Mcmurry Today, 8:45 AM
Time for some levity
Thread Starter: Dave Anderson NHWith all of the negativity and political stuff going on with the Covid-19 virus it is time to look at the humorous side of things. Feel free to add more, but keep it clean or it will be deleted.
Last Post By: Jim Allen Yesterday, 12:22 PM