• Recent Articles

  • Recent Article Comments Widget

  • Hottest Threads

    Dave Anderson NH

    Time for some levity

    Thread Starter: Dave Anderson NH

    With all of the negativity and political stuff going on with the Covid-19 virus it is time to look at the humorous side of things. Feel free to add more, but keep it clean or it will be deleted.

    Last Post By: Jim Allen Yesterday, 4:18 PM Go to last post
    Matt Lau

    Those proud of their workshops, please post pics!

    Thread Starter: Matt Lau

    I'll finally be non-nomadic, and I'd like to finally build up a workshop. Before I get started, I'd love to get ideas. I'd love to see how you do things, and how you do things differently with all the disciplines here: tuners, neanders, power tool users, festoolies, etc. For those of you who...

    Last Post By: Kevin Jenness Yesterday, 8:25 AM Go to last post
    Blake M Williams

    Saw advice

    Thread Starter: Blake M Williams

    I'm almost a completely 100% hand tool user. I would like to get away from using the band saw for cutting lumber down to workable pieces and cut it all by hand. I have a dovetail and tenon saws, what I need are the bigger saws. I think I could maintain and keep a good saw sharp but I do not have...

    Last Post By: Blake M Williams Yesterday, 8:47 PM Go to last post
    Phil Mueller

    Usps

    Thread Starter: Phil Mueller

    I have to give the USPS some credit for dealing with this Covid chaos. I think they’ve done a pretty decent job given the increase in online deliveries, holding mail for thousands of closed businesses, all with reduced staff. Occasionally, though, things do go a bit awry. I have one package I...

    Last Post By: Ron Citerone Yesterday, 10:25 PM Go to last post
    andrew whicker

    Driver bit organizer (portable)

    Thread Starter: andrew whicker

    Seemed like this would be a simple thing.. just need an empty case with empty slots, etc to store bits. Bosch almost does this. They sell an empty case, but they don't sell empty slots to hold your bits. As with most of you, I have a million billion bits already and don't need to buy more. ...

    Last Post By: John C Ritchie Yesterday, 3:14 PM Go to last post
    Shawn Siegrist

    Super Nova II chuck

    Thread Starter: Shawn Siegrist

    I have a 1 1/4” direct thread Super Nova II chuck. I’ve had the chuck for about a week, very happy with it. Maybe I’m missing something obvious but what is the best way to remove the chuck from the lathe? There doesn’t appear to be flat spots for a wrench, any suggestions??? Thanks, Shawn

    Last Post By: Eric Cothern Yesterday, 11:08 PM Go to last post
  • Tom Bain

    There is no available content written by Tom Bain