• Recent Articles

  • Recent Article Comments Widget

  • Hottest Threads

    Dave Anderson NH

    Time for some levity

    Thread Starter: Dave Anderson NH

    With all of the negativity and political stuff going on with the Covid-19 virus it is time to look at the humorous side of things. Feel free to add more, but keep it clean or it will be deleted.

    Last Post By: Ed Aumiller Yesterday, 10:13 PM Go to last post
    ken hatch

    Bevels

    Thread Starter: ken hatch

    I asked this question on another thread. What's with the multiple bevels, over the last couple or three weeks I keep seeing mention of primary, secondary, and even tertiary bevels. Most of the time Rob Cosman is also given credit as in "sharpened as Rob Cosman does". Why? Is it a honing guide...

    Last Post By: steven c newman Yesterday, 1:07 PM Go to last post
    steven c newman

    A Project for July?

    Thread Starter: steven c newman

    Well....I did have a stack or two of scraps... And a couple of Pine boards sitting around, doing nothing constructive And a couple handy panels of plywood.... That needed a job. Sorted through the Ash scraps....had 11 pieces, tossed out 2...They needed squared up, so they were all about...

    Last Post By: steven c newman Yesterday, 4:43 PM Go to last post
    Derek Cohen

    Marking knives for joinery

    Thread Starter: Derek Cohen

    These are some the knives I have collected over the years and use for laying out joinery. Obviously not all at the same time :) Three popular knives - these ones get a lot of use. From the top down ... Swann-Morton fixed blade, Stanley swivel blade, and a Swann-Morton craft knife which was my...

    Last Post By: Kevin Groenke Yesterday, 2:52 PM Go to last post
    george wilson

    Still alive

    Thread Starter: george wilson

    I havenít been posting on any forum for nearly two years. Somehow I just seem to have lost interest. Iím still alive though !

    Last Post By: Ernie Miller Today, 12:14 AM Go to last post
    Jim Koepke

    Was it just my imagination?

    Thread Starter: Jim Koepke

    Was there a recent post on the "Unicorn Edge" or some such? Having looked at another forum to see what this was about, it was put on a back burner to give a try. Finally had a plane blade to give it a try. It did provide a very good edge able to make an incredibly thin shaving on a piece...

    Last Post By: Winston Chang Today, 12:56 AM Go to last post
  • Kevin M. Adams

    There is no available content written by Kevin M. Adams