• Aaron Koehl

    by Published on 02-27-2011 5:33 PM     Number of Views: 17502 

    Do you have woodworking knowledge you're just dying to share?
    Want to be an author at Sawmill Creek?

    Now you have a new area to publish articles!

    If you want to publish an article, you can join our authors group, which gives you access to a forum which is open only to would-be authors at SawmillCreek. This is a staging area for new articles, where you can post a new article, and we'll review for publication. Once you're ready to publish it, we'll promote it on the front page of SawmillCreek!


    The process is simple:

    1. Join the Authors group by visiting this page.
    2. Once you have access, visit the Authors forum.
    3. Start your article by creating a new thread in that forum.


    TIPS

    If your article is too long for a single post, don't fret ! Spread your article over multiple posts, and we'll merge them together into a single post when the article is ready to be published.

    Try posting pictures inline for visual interest.

    Choose a catchy, yet descriptive title!

    Writer's Block?

    We're looking for tool reviews, woodworking tips, woodturning techniques, jigs and fixtures, finished projects step-by-step, finishing techniques, social woodworking experiences, and even good compilations of our existing thread topics.

    Good luck and Happy writing!
    _Aaron Koehl_
    Published on 01-05-2011 7:24 PM     Number of Views: 29648 
    Article Preview

    An article on segmented bowls by one of our original moderators, Ken Salisbury.

    This article describes the process used to make the following bowl.

    ...
    Published on 01-02-2011 5:43 PM     Number of Views: 5309 

    Jack Explores the excitement and some of the challenges he faced when
    introducing children to woodworking.
    ...
  • Recent Polls

    Which fence: (Votes: 12)

    1. Delta Biesemeyer 78919B Type 2 (Votes: 2)

    2. SawStop TGP2-FA (Votes: 6)

    3. Something else (Votes: 4)

  • Recent Forum Posts

    Jim Dwight

    Safety options for my 'naked' PM66

    You cannot use a guard for very thin cuts since it interferes with the rip fence. You can't use either the riving knife or the guard for dado cuts.

    Jim Dwight Today, 8:21 AM Go to last post
    Bill George

    S30 vs S 30C spindle

    My understanding ceramic bearings were used in part because in a VFD driven motor eddy currents are generated in the rotor and that current passes through

    Bill George Today, 8:17 AM Go to last post
    Nicole Wood

    Chevron Table Top, alternate to veneering?

    Hi All, I am contemplating how to build a dining table top that has a chevron pattern of hard maple, in 3" strips. Conventional wisdom is to veneer

    Nicole Wood Today, 8:12 AM Go to last post
    George Bokros

    Guess That Estimate!

    Fender (including blending on to the hood) $1,200 and taillight panel paint $350, rocker trim reinstall $300, Total including supplies and tax $1900.

    George Bokros Today, 8:00 AM Go to last post
    Joe Bradshaw

    WTB - 1/2 corded drill

    John, I have a Bosch drill/hammer drill that is excess to my needs. Shoot me your address, and I will get it packaged up and sent off to You.
    Joe

    Joe Bradshaw Today, 7:46 AM Go to last post
  • Recent Blog Posts