• Recent Articles

  • Recent Article Comments Widget

  • Hottest Threads

    Kev Williams

    Had the most pleasant shopping experience yesterday--

    Thread Starter: Kev Williams

    Needed to go to Walmart for a few things. They implemented a mandatory mask rule last weekend. When I pulled into the parking lot first thing I noticed was there was barely half as many cars than normal, maybe less. The south doors were locked, entry/exit from the north doors only. Went in, grabbed...

    Last Post By: Mike Goetzke Today, 11:03 AM Go to last post
    Dan Kraakenes

    Veritas LA/BU planes or Custom planes?

    Thread Starter: Dan Kraakenes

    Im considering upgrading my single plane to more dedicated 4,5,7 planes. Im currently used to a #4, but I have to large hands for it, so was first thinking of upgrading to a 4 1/2. But.. then again I am wondering if I should go for the Low Angle / Bevel up planes or the "Custom" Veritas...

    Last Post By: Jim Koepke Today, 10:39 AM Go to last post
    Frederick Skelly

    Do YOU use handscrew clamps?

    Thread Starter: Frederick Skelly

    There's another thread where a guy in europe is buying a bunch of clamps and asked for advice. There's some back and forth about wooden handscrew clamps. (Like these) One man says everybody has some but most people don't use them often. Another man says he uses them for a lot of things. I didnt...

    Last Post By: Jeff Bartley Yesterday, 2:35 PM Go to last post
    Rich Riddle

    Vintage Cars

    Thread Starter: Rich Riddle

    The wife's 1956 Ford Thunderbird will be delivered next week from the body shop (since January 2019). When it arrives, the wife's 1965 Mustang heads down to be restored (going from blue to white). She won't restore her old 1991 Ford F150 though. She might look for a 1960's vintage Camaro soon. What...

    Last Post By: Mike Henderson Today, 12:28 PM Go to last post
    ken hatch

    More on Unicorn Profile

    Thread Starter: ken hatch

    I'm still crippling around on a bad wheel so not much is happening in the shop even sharpening is too much some days. There have been a few days where whisky and a elevated foot was all I could do. On one of the good days I did install a stitched cotton wheel on the grinder and have taken a...

    Last Post By: Kevin Adams Today, 12:48 PM Go to last post
    Lisa Starr

    Help me choose new ROS-please

    Thread Starter: Lisa Starr

    Well, my Dewalt ROS (DWC6421) has died. I've been perfectly happy with it and it owes me nothing. That said, I'd like your thoughts before purchasing a new one. I'd like to stay under $200 and have some other wishes. 1) Uses 5" discs, hook & loop, as I have lots of stock. 2) Reasonably...

    Last Post By: Dave Sabo Today, 12:58 PM Go to last post
  • Malcolm Schweizer

    There is no available content written by Malcolm Schweizer