Due to health reasons, I can no longer use my shop, I'll be selling everything starting with my Lathe tools and the Powermatic 3520B: Woodcutter coring tool W/laser. $350 Sorby texturing tools - the complete set W/ micro set. $250 Sorby captive ring tool set (3 pc.) $60 Elbow hollowing tool W/...
Last Post By: David Schmittou Today, 6:23 PMHi, Everyone. I dearly love this forum, although I have not posted in a long time. You folks are so knowledgeable and always have such great suggestions. Here is my situation. I make a small music accessory and need to build my own saw. Without going into all the details, I've been searching for...
Last Post By: Jim Becker Today, 7:11 PMIn my small shop most things are kept in drawers and anything like packaging is turfed out rather than claiming space. Tools like drills share bits etc with other drills and are easily accessed from drawers. If my router lived in a Systainer the accessories would have to live elsewhere, at least...
Last Post By: Jim Becker Today, 1:18 PMI have a Gitzo tripod that was bought in the late 1970s. The rubber ring for tightening the nut on the telescoping section to raise and lower the camera has finally stretched to the point of uselessness. Years ago when talking to a rep. at Gitzo I was told the part is unavailable and my model...
Last Post By: Jim Koepke Today, 6:59 PMI've got a 23 HP diesel Kioti tractor, 3 years old. As I was operating the backhoe at about 1/2 throttle, the engine suddenly over revved, smoked for less than 10 seconds and then died. I checked all fluids, temps, etc looked over the engine for any obvious problem and all was fine. To my...
Last Post By: Tom M King Today, 7:11 PMSure - why not? (Votes: 9)
Never. If I needed something, I'd buy or rent it. (Votes: 10)
Maybe. Depends on the person and the tool. (Votes: 52)
Sounds interesting, but I'm not a machinery guy for the most part.
Jim Becker Today, 7:11 PMDiesel fuel sitting over a Winter shouldn’t be much of an issue. My 100 gallon tank has sat over Winters for 30 years with some in it. I do use some
Tom M King Today, 7:11 PMSo..was a long day...but..
All 9 are done for THIS side...next?
Need to transfer all the layout marks to the case's other
Blanks
I have been buying laser engrave blanks from amazon but now that the 300 watt laser is cutting metal really good
I will be cutting
Yes, floor model with sharpenable blades. They needed to be replaced many years before I did. I finally ran out of area that had usable blade. If I
Michael Schuch Today, 7:07 PM
Lumber supply
Thread Starter: steven c newmanHas been restocked.. Bought 10 planks...for $30...had to cut a few of the 10 footers down, to fit into the Trunk of my Chevy Equinox... Eight 1 x 6 x 6' Five 1 x 4 x 6' And he threw in a stack of shorts And a 3/4" x 8" x 39" slab..
Last Post By: steven c newman Today, 7:10 PM