• Recent Articles

  • Recent Article Comments Widget

  • Hottest Threads

    Jon Snider

    New shop build, the MBS

    Thread Starter: Jon Snider

    I’ve received some offline encouragement to post some content of my new shop build. If you’ve read any of my other numerous questions (thx all for invaluable help), I’ve been at this since last April. Here is an effort to slowly catch up. The shop replaces the same spot where I built a veggie...

    Last Post By: Jim Becker Today, 10:09 AM Go to last post
    Paul F Franklin

    New Lee Valley Web Site

    Thread Starter: Paul F Franklin

    Seems the roll out of the new site is not going completely smoothly. Have been trying to place an order all morning and the site just spins when I try to checkout. Tried a few different browsers too. Guess I may have to call :eek: New site design seems nice and clean though but it will take...

    Last Post By: Frederick Skelly Yesterday, 8:41 PM Go to last post
    Thomas Crawford

    restoring a powermatic 15HH

    Thread Starter: Thomas Crawford

    So this thing followed me home finally last week. Its a bit of a mess but I'm hoping I can get it all cleaned up.

    Last Post By: Matt Day Yesterday, 9:23 PM Go to last post
    Derek Cohen

    The start of a build

    Thread Starter: Derek Cohen

    I thought that the build might begin with preparing the panels, since there has been some interest in the past shown in the shorter Hammer K3 sliders. Mine has a 49" long slider and a 31" wide table for the rip fence. The build is an entry hall table for a wedding present for a niece. Her...

    Last Post By: Tom Bender Today, 7:47 AM Go to last post
    ChrisA Edwards

    Looking for Basswood within a 500 mile radius of Nashville TN

    Thread Starter: ChrisA Edwards

    Went down to the lumber distributer, where I bought $1300 of Basswood last summer, with the plan to buy about $800 worth today (that's what will fit in the bed of my truck). I need about 800 board/feet. They informed me that they had changed their policy a couple of months ago. They used to...

    Last Post By: ChrisA Edwards Today, 2:09 PM Go to last post
    Jamie Buxton

    Small diameter ROS sanders?

    Thread Starter: Jamie Buxton

    I'm looking at small-diameter random orbit sanders, which I would use to sand concave furniture parts -- like scooped-out chair seats, and sculpted back rails. I think my sanding problem is the same as a turner sanding the inside of a bowl, hence the post here. I don't have a big compressor, so...

    Last Post By: Stan Smith Yesterday, 2:52 PM Go to last post
  • Frederick Skelly

    There is no available content written by Frederick Skelly