• Recent Articles

  • Recent Article Comments Widget

  • Hottest Threads

    Dave Anderson NH

    Time for some levity

    Thread Starter: Dave Anderson NH

    With all of the negativity and political stuff going on with the Covid-19 virus it is time to look at the humorous side of things. Feel free to add more, but keep it clean or it will be deleted.

    Last Post By: Bruce Page Yesterday, 10:59 PM Go to last post
    Phil Mueller

    Made in China sentiment

    Thread Starter: Phil Mueller

    As a retail small business owner, selling a number of high quality made in China products, Im curious of any changes in consumer sentiment. Given the current pandemic, will made in China products be more of a deal breaker, or the same? Obviously, if you avoided made in China in the past, you...

    Last Post By: Doug Dawson Yesterday, 7:01 PM Go to last post
    Randall J Cox

    Outdoor Paitio Furniture Wood Recommendation?

    Thread Starter: Randall J Cox

    Looking at building 4 good sized outdoor chairs. Talked with specialty hardwood lumber co folks and of white oak, mahogany or hard maple, the rock maple was the cheapest by far. I have built a couple of large patio tables out of white oak and unless I keep them covered during the winter rainy...

    Last Post By: Alex Zeller Yesterday, 6:42 AM Go to last post
    Aaron Rosenthal

    Will you go back to your place of employment?

    Thread Starter: Aaron Rosenthal

    Im semi retired, so aside from a few friends who regularly call on me for repairs, and my charitable work, an office or steady away from home workspace is not a concern. Many of you out there are working from home or are otherwise stuck there. It reminds me of the old I married you for better...

    Last Post By: Jim Becker Yesterday, 12:27 PM Go to last post
    Dan Gaylin

    Forstner bit problems

    Thread Starter: Dan Gaylin

    So I was doing the rare bit of spindle work (I mostly do bowls) and I was trying to get a 1 3/4” diameter recess for a candle in a cherry candlestick I had turned. I put my 2 MT drill chuck in the tail stock and put a 1 3/4” forstner bit into the chuck. Set my lathe to its lowest speed. Brought...

    Last Post By: Richard Coers Yesterday, 11:44 PM Go to last post
    Andrew Dale

    Minimax/Tecnomax CU410 Elite

    Thread Starter: Andrew Dale

    Hey everyone! I'm relatively new here in posting, but have been a lurker for quite some time. I've come upon the opportunity to buy the machine in the title, a 2007 SCM Tecnomax CU410 Elite. Having a smaller shop, it's somewhat a dream to be able to have something this functional in such a...

    Last Post By: Jim Becker Yesterday, 8:50 AM Go to last post
  • Frederick Skelly

    There is no available content written by Frederick Skelly