View RSS Feed

Jon Lanier

Decal Pen Tutorial (Part 1)

Rate this Entry
Here is what I basically do with my Decal pens. As you can see I use Testors Decal paper. This can be found at Hobby stores. I purchased mine at “Hobby Lobby.”

Just follow the directions for printing out your logo, name…etc. One thing I have found using this material is that you MUST use a light colored blank for the background. This is transparent film, but the inkjet inks are not solid enough for darker colors. That type of decal must be purchased through professional modeler companies.



After printing out your decal you must spray this setting compound. It to can be purchased at the same place you buy the decal paper. These go hand in hand and one cannot be used without the other. But becareful not to over spray. Overspraying can stiffen the decal up so it won’t bend around your pen.



Now, lets assume to this point that you have turned your blank. For prepping the barrel for decal I follow these simple steps:

1) sand down to 1000 grit
2) Use two thin coats of CA. I use an accelerate after each coat.
3) Micro Mesh the barrel 1500—12000 grit
4) DO NOT BUFF

The barrel should be nice a smooth at this point.

Now is the time to cut out your decals. Keep the trim close but not to close that you can’t handle the piece. Size it up to where you would like it on the barrel.



Take your decal and let is soak in some cool water (you can read the direction on package for this step).




(Go to part 2)
Categories
Uncategorized

Comments