On the other one, I have a much shorter track, as that is easy to wield for typical hardwood cuts & 2X4's. I have this even though I own an EZ-ONE table, because I like to work outside in the sunshine whenever possible. Thus, I use my "Smart" table (built primarily for cutting down sheet goods, typically right in the driveway) outdoors, with various attachments, for all sorts of "serious" woodworking. (I also use hand tools, but sometimes I'm just lazy, or can't afford to make a flase cut.) Anyway, until you use one of these miter squares, you won't realize how easy and accurate they are. Last edited by Allan Speers; 09-24-2015 at 12:21 AM.
Basically, it's a miter fence with a handle, and a short piece of track attached, tightened to whatever angle you need, vs the handle. I have two, because I like to keep one always at 90 degrees, and that one is JB Welded solid. (dead nuts accurate. My track is just long enough to cut across a 4' sheet, with room on the end for saw support. __________________________________________________ ________ Now being the proud owner of several thousand dollars worth of Eureka Zone Tools you have piqued my interest with these EZ Miter square dingus's accessories. Is there any way to get a picture of these or a drawing. Anything at all would be appreciated! Thanks in Advance, Bruce Hough A.K.A. - "The EZ Thief" BHough56@yahoo.com for direct email
Dear Allen, My name is Bruce Hough(bhough56 on Eureka zone forums) I was lurking on smc recently and found one of your posts. The link is: http://www.sawmillcreek.org/showthre...tracksaw/page3 The conversation goes as follows: What you'll want is the EZ miter square dingus, as I may have mentioned earlier. (Or in another thread.) I use it more than the actual bench, and would REALLY hate to be without it.
