Conversation Between Joe Jensen and Peter Franklin

2 Visitor Messages

  1. Hi Peter, you need to tighten the small nut which will pull a tapered pin out of the bushing. Before I realized that I chewed the slots on a couple of bushings. If you have already removed the tapered pins the next step would be a penetrating oil and heat. I had no trouble once the tapered pins were removed.
  2. Hi Joe
    I'm tuning up an Scmi f3a and came across your post. Wondering if you had any problem adjusting the eccentric bushings to adjust the tables to coplaner? Mine are stuck solid. My unit is 40 years old so perhaps age as got them sticking but hoping there's a simple fix rather than taking the whole machine apart. Any ideas? Thanks much!
    PF
Showing Visitor Messages 1 to 2 of 2