About a month ago I began a thread about designing and building two carver chairs to accompany the 6 bentwood chairs we have owned for the past 40 years. The chairs were purchased all those years ago along with a table, which is around 200 years old. We need a larger table, and time has come to...
Last Post By: Larry Frank Yesterday, 8:42 PMHad a 7.5 baldor, had a seperate post on this because I thought I figured out what was going on but evidently this is beyond my knowledge or experience. I replaced caps on 7.5 baldor, no difference, bought new leeson 7.5 hp, both single phase motors, got it hooked up, check wiring, cranked...
Last Post By: Jimmy Harris Today, 11:46 AMI've got a well head cabinet/enclosure to make which is in a remote location, about a 2 mile hike through the mountains without any trails. I've spent a few hours making measurements, and we will likely make this in sections, and strap them to our backs and assemble it in the field. There is no...
Last Post By: Maurice Mcmurry Today, 7:46 AMMy router on the recently purchased router table quit, it came on then off then on now it will not come on. I have it pulled apart trying to get all the sawdust out of the connections, it's embedded pretty bad, not sure if that is the cause but worth a try. I found another identical one on eBay for...
Last Post By: chris hood Yesterday, 10:16 PMI have a 2019 Grasshopper mower with Kubota D902 engine that suddenly won't start at low throttle. I have always started it at the lowest throttle setting and it started just fine. Now, it simply won't start at the lowest throttle setting. I thought something was seriously wrong, and I was just...
Last Post By: Jerome Stanek Today, 11:27 AMBeen doing it like (or equivalent) this for years. (Votes: 4)
Wow! Never thought of that. (Votes: 0)
Been doing it with mirrors. (Votes: 2)
Ain't got a boat, truck, care… (Votes: 0)
As an update, my brother still wants to sell the package as a whole. Anyone with genuine interest will have their every question answered. His hope is
Mary Andre Today, 2:05 PMI leave the baseline mark on hand cut dovetails, also, just to show they were hand cut. Another thing you can do is to make the tails different sizes.
Mike Henderson Today, 1:57 PMPartially just good luck. I lay the wood next to each other to see what it might look like, sometimes even putting alcohol on it to see what it might
Mike Henderson Today, 1:51 PMIn German many words are often just run together. This one generally translates to "Flooring sanding machine rental."
A person
Time for some levity
Thread Starter: Dave Anderson NHWith all of the negativity and political stuff going on with the Covid-19 virus it is time to look at the humorous side of things. Feel free to add more, but keep it clean or it will be deleted.
Last Post By: Doug Garson Today, 2:11 PM