• Recent Articles

  • Hottest Threads

    ken hatch

    Bevels

    Thread Starter: ken hatch

    I asked this question on another thread. What's with the multiple bevels, over the last couple or three weeks I keep seeing mention of primary, secondary, and even tertiary bevels. Most of the time Rob Cosman is also given credit as in "sharpened as Rob Cosman does". Why? Is it a honing guide...

    Last Post By: steven c newman Today, 1:07 PM Go to last post
    Bert Kemp

    Camera Question

    Thread Starter: Bert Kemp

    First of all I know nothing about DSLR's but have a love for photography. Always had Digital point and shoots, but their limited in what they can do. Anyway long story short a Friend of mine gave me one of his old cameras a Canon 60D the day he gave it to me he took off on a vacation to return who...

    Last Post By: Bert Kemp Yesterday, 8:54 PM Go to last post
    steven c newman

    A Project for July?

    Thread Starter: steven c newman

    Well....I did have a stack or two of scraps... And a couple of Pine boards sitting around, doing nothing constructive And a couple handy panels of plywood.... That needed a job. Sorted through the Ash scraps....had 11 pieces, tossed out 2...They needed squared up, so they were all about...

    Last Post By: steven c newman Today, 4:43 PM Go to last post
    Derek Cohen

    Marking knives for joinery

    Thread Starter: Derek Cohen

    These are some the knives I have collected over the years and use for laying out joinery. Obviously not all at the same time :) Three popular knives - these ones get a lot of use. From the top down ... Swann-Morton fixed blade, Stanley swivel blade, and a Swann-Morton craft knife which was my...

    Last Post By: Kevin Groenke Today, 2:52 PM Go to last post
    William Chain

    Tall Case Oak Clock

    Thread Starter: William Chain

    I've just completed my most complicated project so far - a tall case oak clock based on the plans from Norm Abram and the New Yankee Workshop. From first rough stock into the garage to accurate timepiece in the hall was just about 8 months to the day. The plans I got were very outdated and...

    Last Post By: William Chain Today, 12:57 PM Go to last post
    Jim Koepke

    Was it just my imagination?

    Thread Starter: Jim Koepke

    Was there a recent post on the "Unicorn Edge" or some such? Having looked at another forum to see what this was about, it was put on a back burner to give a try. Finally had a plane blade to give it a try. It did provide a very good edge able to make an incredibly thin shaving on a piece...

    Last Post By: ken hatch Today, 6:03 PM Go to last post