Looking for a new project to do. I've been spending a few months upgrading the workshop / fixing minor annoyances, and really need to actually build something. I ran across this in a magazine ad. The furniture is supposedly solid teak, though I don't think that will be in the cards for...
Last Post By: Kevin Jenness Yesterday, 8:08 PMI have a 2019 Grasshopper mower with Kubota D902 engine that suddenly won't start at low throttle. I have always started it at the lowest throttle setting and it started just fine. Now, it simply won't start at the lowest throttle setting. I thought something was seriously wrong, and I was just...
Last Post By: Curt Harms Yesterday, 12:00 PMThis thread has no redeeming value. You have been warned. Got an ECE block plane here recently. Solely out of curiosity went I looking around, and found LV carries ECE planes, but not this one, but they do have replacement blades for it - which I will never need. Even so - I was pondering...
Last Post By: steven c newman Yesterday, 3:01 PMRegulated season opened yesterday. Trip to Savannah, veered off the interstate to get some
Last Post By: Maurice Mcmurry Yesterday, 6:18 PMHi all, I have an older Delta 6" jointer model 37-190 which I've been trying to change the knife blades on (first time doing so). I penetrating oil on the knife bolts but 4 of the screw heads are starting to strip with the 5/16" open end wrench I've been using. I first tried using an 8mm...
Last Post By: Tom M King Yesterday, 7:33 PMBeen doing it like (or equivalent) this for years. (Votes: 4)
Wow! Never thought of that. (Votes: 0)
Been doing it with mirrors. (Votes: 2)
Ain't got a boat, truck, care… (Votes: 0)
I had an 8" Freud Super Dado set that was actually a whisker (1/8") over 8" and wouldn't work with the SawStop dado brake. I ended up
Ken Krawford Today, 6:19 AMI bought the saw for 950 euros in decent shape. There are 8 large ball bearings. The sliding table has a little bit of play when fully extended. The ball
Stanea Laurentiu Today, 3:24 AMI think that switch is really meant for 13A 3-phase. That's about what a 3-phase 5HP motor would use. Trying to use the switch for single phase will
Aaron Inami Today, 12:10 AM
Time for some levity
Thread Starter: Dave Anderson NHWith all of the negativity and political stuff going on with the Covid-19 virus it is time to look at the humorous side of things. Feel free to add more, but keep it clean or it will be deleted.
Last Post By: Cameron Wood Yesterday, 2:54 PM