I need to pick up some more clamps in the 36 inch range. I figured I’d see if anybody had any value options that work well. I have some Bessy and Jorge now but just trying to save a couple bucks.
Last Post By: David Walser Today, 2:40 PMSeems like questions about Minimax bandsaws have been popping up and I wondered if there could be an opportunity to condense knowledge into and level-set some best-practices for setup? First, any contemporary Italian or large Austrian bandsaw ought be very straightforward to set up and get cutting...
Last Post By: Chris Parks Yesterday, 7:22 PMIn a Master ( and only) Bathroom in the house...where all the wood cabinets are real wood...with raised panel doors.....these are to be changed over next.. Butt jointed corners, surrounding flat, plywood panels...20 coats+ of white paint ( Lead?) was supposed to be 4 doors here, until someone...
Last Post By: steven c newman Today, 1:24 PMHi, I am back with more questions. Picked up a block plane at the flea market last week. It has no manufacture ID on it. Using EBay for ideas, I found it was similar to a Craftsman and a Winchester 9” block plane with an adjustable mouth. The lateral adjuster is missing and it was rusted to beat...
Last Post By: steven c newman Today, 12:05 PMHi folks, I am wanting to clean my table saw top. I am going to use a maroon scouring pad with wd40 but want to know what will take the wd40 off so I can wax it. Some videos just say use a degreaser but I was going to use purple power and when I fact checked it stated that it MAY not be good...
Last Post By: Nathan Sampson Yesterday, 9:58 PMUntil it is falling apart and things fall out. (Votes: 35)
Until someone gives me a new on as a gift. (Votes: 5)
Whenever I feel like it. (Votes: 5)
I have many wallets and rotate them. (Votes: 0)
Don't carry a wallet. (Votes: 2)
I use a money clip instead. (Votes: 1)
Sounds interesting...post some pics when you get chance.
Christian Hawkshaw Today, 5:29 PMPre-hurricane bump and price reduction to $170 + shipping.
Wish us luck with Helene!!!
As I get back to work* on the two trestles either end of my walnut table, I am wondering how far beyond the reference edge and face I need to prepare/plane
Tony Wilkins Today, 5:11 PM8'9" is 105" which is what you need if you have a riser block on a Delta, ShopFox, Jet, etc. band saw. So that's a pretty common length. Seems
Jay Houghton Today, 5:01 PMGeorge, I had a friend who was also a lifelong boat mechanic. He told me so many people told him that they enjoyed their first smaller boat more than
Ron Citerone Today, 4:59 PM
The Tips and Tricks Thread
Thread Starter: Ole AndersonOK, let's see if this gets legs. Some time ago I asked (in the Forum Tech Support forum which apparently almost no one reads) if we could have a separate forum dedicated to workshop tips and tricks. Well that didn't go anywhere, so why not just have a thread dedicated to your ideas around the...
Last Post By: Cameron Wood Today, 4:06 PM