We are changing the way we have been offering DVD's of our file attachments to those of you who are interested in purchasing the discs. In the past we offered DVD sets that included file attachments from every forum, starting today we will only offer DVD's from each individual forum. The reason for...
Last Post By: Robert Mangas Today, 10:23 AMDoes anyone have experience or thoughts about the new woodpecker drill press fence? Basically it is hollow aluminum rectangle tube with with an opening in the center and attachment for a shop vac on the end. This allows the fence to be a conduit for dust collection. The link below also show the...
Last Post By: Mike Goetzke Today, 10:13 PMAnyone here own any of these saws or have any gripes/good things to say about them? I have an old 36” crescent which is a well built machine but has a multitude of issues that aren’t worth it to me to fix. Looking at these smaller 24”ish saws to replace it. Primary uses resawing up to 8”...
Last Post By: Thomas Eustis Today, 9:57 PMhttps://www.harveywoodworking.com/collections/table-saws?sort_by=price-ascending Looks like they just released some new models including what interests me most a $1595 2hp model with 31 1/2" deep table. Am i missing a saw or is that somewhat a class of its own?
Last Post By: Jim Lafferty Today, 10:13 AMThis has been nearly finished for quite a while. I had a misadventure with the alignment of one of the doors. I needed a long cooling-off period after my first couple of attempts failed to fix the problem. I used the plan for the bottom unit of the Country Hutch by Martin Milkovits in Fine...
Last Post By: Bill Carey Today, 12:24 PMYes, I would (Votes: 27)
No, I wouldn't (Votes: 2)
Check the TPR valve on the top or side of the water heater. If the discharge pipe is piped to a place where it’s not readily visible you would not
Bruce King Today, 11:06 PMI purchased what is essentially a brand new DW735 planer from someone on Craigslist. He told me the planer head is very tight, and takes MUCH more oomph
Leo Butler Today, 11:05 PMI wonder if Ben's lathe is the G0766 or another model? Grizzly will do right by him, if he calls customer service, and the unit is under warranty.
Roger Chandler Today, 10:58 PMWith the kerfs deepened, remove all the blue tape, and deepen the base lines ...
Undercut the baselines to create a chisel
This is the 14th chapter in the Underbench Cabinet build. The thread has become quite long, and now needs to have a fresh start. Note that this is not
Derek Cohen Today, 10:57 PM
Time for some levity
Thread Starter: Dave Anderson NHWith all of the negativity and political stuff going on with the Covid-19 virus it is time to look at the humorous side of things. Feel free to add more, but keep it clean or it will be deleted.
Last Post By: Jim Allen Today, 6:19 PM