Has been restocked.. Bought 10 planks...for $30...had to cut a few of the 10 footers down, to fit into the Trunk of my Chevy Equinox... Eight 1 x 6 x 6' Five 1 x 4 x 6' And he threw in a stack of shorts And a 3/4" x 8" x 39" slab..
Last Post By: steven c newman Yesterday, 12:56 PMHad a 7.5 baldor, had a seperate post on this because I thought I figured out what was going on but evidently this is beyond my knowledge or experience. I replaced caps on 7.5 baldor, no difference, bought new leeson 7.5 hp, both single phase motors, got it hooked up, check wiring, cranked...
Last Post By: Ronald Blue Today, 9:43 AMOne of those sitting at the computer in the morning with a cup of coffee itching to buy a new tool ... So I come across this Veritas Scraper Burnisher for Turners and looked at a few videos reviews of it and thought why not. After reading a few reviews posted on this forum I later realized it was...
Last Post By: stephen thomas Yesterday, 1:46 PMMy router on the recently purchased router table quit, it came on then off then on now it will not come on. I have it pulled apart trying to get all the sawdust out of the connections, it's embedded pretty bad, not sure if that is the cause but worth a try. I found another identical one on eBay for...
Last Post By: Ronald Blue Today, 8:39 AMI'm pondering the economics of a mill vs buying rough lumber at retail/wholesale. In the Bay Area, depending on where you shop hardwoods like Oak and walnut can run up to $15-18bf/ft, or more for the rift/quarter sawn stuff. If one is able to source your own logs, running your own mil and kiln...
Last Post By: Rod Sheridan Yesterday, 8:29 PMBeen doing it like (or equivalent) this for years. (Votes: 4)
Wow! Never thought of that. (Votes: 0)
Been doing it with mirrors. (Votes: 2)
Ain't got a boat, truck, care… (Votes: 0)
Do you have any other tools running on 240 volts currently? Just to confirm that you have two separate phases. It sounds like you do if you measured 239
Ronald Blue Today, 9:43 AMThis would be done in steps. I think you would need multiple bits to accomplish this. I would profile to max LOC then I would use a 1/2" ball to
George Yetka Today, 9:39 AMDid you try rubbing the surface with burlap or a mirka mirlon pad to smooth things out in between coats? That worked for me when I used Real Milk Paint
Peter Mich Today, 9:38 AMI agree with this. Your old Meber maxes out at what? 1" blade? For resawing, the thicker the blade, the better. The Laguna 18bx will go up to
Jimmy Harris Today, 9:33 AMWe have one. In fact I just used it to call our cell provider tech support. Cell service is miserable here. Neighbors with house phones by cable lose
Alan Rutherford Today, 9:18 AM
Dining room carver chairs - Take 2
Thread Starter: Derek CohenAbout a month ago I began a thread about designing and building two carver chairs to accompany the 6 bentwood chairs we have owned for the past 40 years. The chairs were purchased all those years ago along with a table, which is around 200 years old. We need a larger table, and time has come to...
Last Post By: Derek Cohen Today, 6:12 AM