Looking for a new project to do. I've been spending a few months upgrading the workshop / fixing minor annoyances, and really need to actually build something. I ran across this in a magazine ad. The furniture is supposedly solid teak, though I don't think that will be in the cards for...
Last Post By: Kevin Jenness Today, 8:08 PMI have a 2019 Grasshopper mower with Kubota D902 engine that suddenly won't start at low throttle. I have always started it at the lowest throttle setting and it started just fine. Now, it simply won't start at the lowest throttle setting. I thought something was seriously wrong, and I was just...
Last Post By: Curt Harms Today, 12:00 PMI've seen threads discussing the pros and cons of straight-sided versus bevel-sided mortise chisels. The big takeaways seem to be 1. Straight sides encourage a straight mortise with less chance of side-to-side wander 2. Chisels with angled sides are easier to extract after a chop and aren't so...
Last Post By: Cameron Wood Yesterday, 11:11 PMThis thread has no redeeming value. You have been warned. Got an ECE block plane here recently. Solely out of curiosity went I looking around, and found LV carries ECE planes, but not this one, but they do have replacement blades for it - which I will never need. Even so - I was pondering...
Last Post By: steven c newman Today, 3:01 PMRegulated season opened yesterday. Trip to Savannah, veered off the interstate to get some
Last Post By: Maurice Mcmurry Today, 6:18 PMBeen doing it like (or equivalent) this for years. (Votes: 4)
Wow! Never thought of that. (Votes: 0)
Been doing it with mirrors. (Votes: 2)
Ain't got a boat, truck, care… (Votes: 0)
The Omga chopsaws I have used were in another league from anything else. CTD is also said to be topnotch. For greater cut width I expect an Omga radial
Kevin Jenness Today, 8:15 PMIt has been a while since I looked but I was surprised to see that Menards had hardwood plywood that was labeled as "Sand-able" with a face
Maurice Mcmurry Today, 8:12 PMCan you post a photo of your setup?
Kevin Jenness Today, 8:08 PMI see super surfacers pop up for sale once in a blue moon. There was a Royal FX that sold for practically nothing on Machinery Max a couple years ago,
Brian Holcombe Today, 8:04 PMSo the flush trim tooling that I ordered arrived right on time. This is a half-inch by 1.5" LOC compression flush trim by SpeTool. It's very nicely
Jim Becker Today, 8:03 PM
Time for some levity
Thread Starter: Dave Anderson NHWith all of the negativity and political stuff going on with the Covid-19 virus it is time to look at the humorous side of things. Feel free to add more, but keep it clean or it will be deleted.
Last Post By: Cameron Wood Today, 2:54 PM