About a month ago I began a thread about designing and building two carver chairs to accompany the 6 bentwood chairs we have owned for the past 40 years. The chairs were purchased all those years ago along with a table, which is around 200 years old. We need a larger table, and time has come to...
Last Post By: Larry Frank Today, 8:42 PMHad a 7.5 baldor, had a seperate post on this because I thought I figured out what was going on but evidently this is beyond my knowledge or experience. I replaced caps on 7.5 baldor, no difference, bought new leeson 7.5 hp, both single phase motors, got it hooked up, check wiring, cranked...
Last Post By: Karl Card Today, 11:01 PMMy router on the recently purchased router table quit, it came on then off then on now it will not come on. I have it pulled apart trying to get all the sawdust out of the connections, it's embedded pretty bad, not sure if that is the cause but worth a try. I found another identical one on eBay for...
Last Post By: chris hood Today, 10:16 PMI've got a well head cabinet/enclosure to make which is in a remote location, about a 2 mile hike through the mountains without any trails. I've spent a few hours making measurements, and we will likely make this in sections, and strap them to our backs and assemble it in the field. There is no...
Last Post By: Mike Henderson Today, 10:21 PMI'm looking to build my first set of cabinets in my kitchen. I'm currently building a new house. I am a third generation general contractor so l have a good degree of knowledge in construction my grandfather used to build furniture and cabinets so I have a very good general idea of how they need to...
Last Post By: Ron Selzer Today, 8:34 PMBeen doing it like (or equivalent) this for years. (Votes: 4)
Wow! Never thought of that. (Votes: 0)
Been doing it with mirrors. (Votes: 2)
Ain't got a boat, truck, care… (Votes: 0)
Yeah someone else had mentioned drilling the holes out as well. I guess once I have it apart I will grind the tabs and drill the holes just in case. I
Shawn Burgess Today, 11:52 PMMy GF cans have 6-digit numbers either on the lid or on the bottom. They don't list their manufacture date system in their facts on their web site but
Mike Chance in Iowa Today, 11:50 PMUnfortunately that looks like my only option at this point.
Thanks for the suggestion.
Yes I can do that. I was hoping to figure out the correct way from the factory to make the adjustment but I have not been able to find that info. Plus
Shawn Burgess Today, 11:48 PMInteresting observations. I wonder if this type is popular with German woodworkers.
Mark Gibney Today, 11:37 PM
Time for some levity
Thread Starter: Dave Anderson NHWith all of the negativity and political stuff going on with the Covid-19 virus it is time to look at the humorous side of things. Feel free to add more, but keep it clean or it will be deleted.
Last Post By: John Ziebron Today, 10:59 PM