I need to pick up some more clamps in the 36 inch range. I figured I’d see if anybody had any value options that work well. I have some Bessy and Jorge now but just trying to save a couple bucks.
Last Post By: Michael Schuch Yesterday, 11:32 PMIn a Master ( and only) Bathroom in the house...where all the wood cabinets are real wood...with raised panel doors.....these are to be changed over next.. Butt jointed corners, surrounding flat, plywood panels...20 coats+ of white paint ( Lead?) was supposed to be 4 doors here, until someone...
Last Post By: steven c newman Yesterday, 1:24 PMHi, I am back with more questions. Picked up a block plane at the flea market last week. It has no manufacture ID on it. Using EBay for ideas, I found it was similar to a Craftsman and a Winchester 9” block plane with an adjustable mouth. The lateral adjuster is missing and it was rusted to beat...
Last Post By: Wayne Nicholson Yesterday, 10:36 PMI"ve never seen anything like it. During the 33 years that I built spec houses on the lake, I saw a few recessions and built a smaller house those years. It was always a mistake as I could just as easily built a big house and still sold it. Land value has always gone up. I'd buy a lot one...
Last Post By: Jim Koepke Today, 12:26 AMI'm looking for a high quality multi-size set of imperial and metric allen wrench bits with 1/4" hex drive. All I can find is cheap junk on amazon, with reports of missing pieces, improper sizes, and fall apart packaging, as well as the small bits snapping off in the screw. Can anyone recommend a...
Last Post By: Brian Holcombe Yesterday, 7:44 AMUntil it is falling apart and things fall out. (Votes: 35)
Until someone gives me a new on as a gift. (Votes: 5)
Whenever I feel like it. (Votes: 5)
I have many wallets and rotate them. (Votes: 0)
Don't carry a wallet. (Votes: 2)
I use a money clip instead. (Votes: 1)
A babbitt bearing head in good shape has tighter tolerances and smoother operation than ball bearings.
Richard Coers Today, 12:59 AMI can imagine that in parts of San Francisco or some other metropolitan areas.
Portland is likely less expensive than many
I even count the ones that look like the seal is intact. Sometimes they are wrong from the supplier.
Our local ACE closed, so for many things
Shucks, late to look. That would fit my 14" bandsaw.
Oh well, glad someone needed it.
jtk
I have a Wahuda bench top jointer. I have had it for over a year.
I have milled a lot of rough sawn pine on it. It took a little practice,
The Tips and Tricks Thread
Thread Starter: Ole AndersonOK, let's see if this gets legs. Some time ago I asked (in the Forum Tech Support forum which apparently almost no one reads) if we could have a separate forum dedicated to workshop tips and tricks. Well that didn't go anywhere, so why not just have a thread dedicated to your ideas around the...
Last Post By: Doug Garson Yesterday, 6:53 PM