I love making windows and doors in my free time, this is my hobby. I eventually want to do timber framing too. A shaper is an important part of making the above, and I want to upgrade. Background: My current machine is a Jet JWS-25CS (3HP, up to 3/4 spindle) I need support for a 1 1/4''...
Last Post By: John Pendery Today, 4:27 PMI need to pick up some more clamps in the 36 inch range. I figured I’d see if anybody had any value options that work well. I have some Bessy and Jorge now but just trying to save a couple bucks.
Last Post By: Tom Bender Today, 8:09 AMSeems like questions about Minimax bandsaws have been popping up and I wondered if there could be an opportunity to condense knowledge into and level-set some best-practices for setup? First, any contemporary Italian or large Austrian bandsaw ought be very straightforward to set up and get cutting...
Last Post By: Tom Trees Today, 8:48 PMThe main electric tool in my shop is a sander and I'd like to use hand tools to finish the wood but I'm curious as to how well a scraping plane or smoothing plane can finish a project compared to sand paper. General I use oil finishes but sometimes stain for contrast. Finishing is my weak area...
Last Post By: Jim Koepke Today, 7:37 PMIn a Master ( and only) Bathroom in the house...where all the wood cabinets are real wood...with raised panel doors.....these are to be changed over next.. Butt jointed corners, surrounding flat, plywood panels...20 coats+ of white paint ( Lead?) was supposed to be 4 doors here, until someone...
Last Post By: steven c newman Today, 4:02 PMUntil it is falling apart and things fall out. (Votes: 35)
Until someone gives me a new on as a gift. (Votes: 5)
Whenever I feel like it. (Votes: 5)
I have many wallets and rotate them. (Votes: 0)
Don't carry a wallet. (Votes: 2)
I use a money clip instead. (Votes: 1)
blades a friend bored out for me so dadoes are 1" and 1.25 for the shaper. I shop for value that is whats the best I can get for the money. l put
Warren Lake Today, 9:36 PMYes, I can swing it up so that I can eyeball along the surface when I'm trying to adjust the roundover bit to be flush. This way I don't have to stay
Zachary Hoyt Today, 9:34 PMwhen you want to adjust the router do you just hinge it back around to upside down then can easily adjust it?
Warren Lake Today, 9:15 PMMy router table is a piece of 3/8" 6061 aluminum plate, 18" square, which cost me about $40 as I recall. I made a hole and mounted a router
Zachary Hoyt Today, 9:05 PM
Time for some levity
Thread Starter: Dave Anderson NHWith all of the negativity and political stuff going on with the Covid-19 virus it is time to look at the humorous side of things. Feel free to add more, but keep it clean or it will be deleted.
Last Post By: Dave Anderson NH Today, 9:37 AM