About a month ago I began a thread about designing and building two carver chairs to accompany the 6 bentwood chairs we have owned for the past 40 years. The chairs were purchased all those years ago along with a table, which is around 200 years old. We need a larger table, and time has come to...
Last Post By: Larry Frank Today, 8:42 PMHad a 7.5 baldor, had a seperate post on this because I thought I figured out what was going on but evidently this is beyond my knowledge or experience. I replaced caps on 7.5 baldor, no difference, bought new leeson 7.5 hp, both single phase motors, got it hooked up, check wiring, cranked...
Last Post By: Karl Card Today, 11:01 PMMy router on the recently purchased router table quit, it came on then off then on now it will not come on. I have it pulled apart trying to get all the sawdust out of the connections, it's embedded pretty bad, not sure if that is the cause but worth a try. I found another identical one on eBay for...
Last Post By: chris hood Today, 10:16 PMI've got a well head cabinet/enclosure to make which is in a remote location, about a 2 mile hike through the mountains without any trails. I've spent a few hours making measurements, and we will likely make this in sections, and strap them to our backs and assemble it in the field. There is no...
Last Post By: Mike Henderson Today, 10:21 PMI'm looking to build my first set of cabinets in my kitchen. I'm currently building a new house. I am a third generation general contractor so l have a good degree of knowledge in construction my grandfather used to build furniture and cabinets so I have a very good general idea of how they need to...
Last Post By: Ron Selzer Today, 8:34 PMBeen doing it like (or equivalent) this for years. (Votes: 4)
Wow! Never thought of that. (Votes: 0)
Been doing it with mirrors. (Votes: 2)
Ain't got a boat, truck, care… (Votes: 0)
What has already been said ^^^^^^^
Plus it won't even fit in most of the applications where one's first instinct would be to grab a side rabbet
All is well now. The first leeson had issues, they sent me a second motor, hooked it up, ran a 2 inch thick piece of brazillian walnut thru it and I
Karl Card Today, 11:01 PMIt looks a lot like the way my Davis and wells saw is built.
Everything hangs off the underside of the table. I have two bolts on the front ways
Looks great. Should last a long time.
Mike
Time for some levity
Thread Starter: Dave Anderson NHWith all of the negativity and political stuff going on with the Covid-19 virus it is time to look at the humorous side of things. Feel free to add more, but keep it clean or it will be deleted.
Last Post By: John Ziebron Today, 10:59 PM