I have a 2019 Grasshopper mower with Kubota D902 engine that suddenly won't start at low throttle. I have always started it at the lowest throttle setting and it started just fine. Now, it simply won't start at the lowest throttle setting. I thought something was seriously wrong, and I was just...
Last Post By: Tom M King Yesterday, 11:55 AMI've got a well head cabinet/enclosure to make which is in a remote location, about a 2 mile hike through the mountains without any trails. I've spent a few hours making measurements, and we will likely make this in sections, and strap them to our backs and assemble it in the field. There is no...
Last Post By: Tony Zona Yesterday, 10:19 PMI didn't want to kidnap Kent's thread so I started this one. Born in the late '40s, I feel blessed to have lived in the 50s, 60s and 70s to experience the musical buffet of the time. From 50s style country music, the folk music era, the Rockibilly era, Motown, the British Invasion and into 70s...
Last Post By: Maurice Mcmurry Today, 7:38 AMThis will be a "build" thread with a bit more detail than I've been doing lately, but it's an interesting project. Some might find it useful; some might scoff. :) But I just can't wait until the end to start posting because it would be too much to post all at once. -------- For background, our...
Last Post By: Jim Becker Yesterday, 4:58 PMHi All, I recently bought the Robust American Beauty. I was hoping the girth and weight of the unit would be enough to keep vibration down but I'm finding it's not. I cored a bowl blank a couple of days ago. I had bandsawed the blank so it wasn't far out of true. The max speed I could get...
Last Post By: Omer Klee Yesterday, 5:40 PMBeen doing it like (or equivalent) this for years. (Votes: 4)
Wow! Never thought of that. (Votes: 0)
Been doing it with mirrors. (Votes: 2)
Ain't got a boat, truck, care… (Votes: 0)
The term "maker" makes my skin crawl
Epoxy woodworker is an oxymoron.
Woodworking is based on a natural material and
Maker is a good word. I mainly work wood but when the soldering iron comes out and I start writing C for an Arduino project, there isn’t any wood in sight!
Michael Burnside Today, 10:12 AMYah that's a beast! I always remove the door knob and deadbolt before finishing a hanging door. Depending on what finish you have in mind, I would but
Maurice Mcmurry Today, 10:07 AMI bought the sander in 2014, I think. About 6 months after I bought-it I found that running pine through in the oscillating mode did not load-up the paper
Sam Puhalovich Today, 9:56 AMThe commercially manufactured wood counters that I am familiar with are maple and were sold by Baer supply in Chicago. They are very stable. In the past
Maurice Mcmurry Today, 9:49 AM
Time for some levity
Thread Starter: Dave Anderson NHWith all of the negativity and political stuff going on with the Covid-19 virus it is time to look at the humorous side of things. Feel free to add more, but keep it clean or it will be deleted.
Last Post By: Paul F Franklin Yesterday, 7:17 PM