Looking for a new project to do. I've been spending a few months upgrading the workshop / fixing minor annoyances, and really need to actually build something. I ran across this in a magazine ad. The furniture is supposedly solid teak, though I don't think that will be in the cards for...
Last Post By: Kevin Jenness Today, 12:51 PMI have a 2019 Grasshopper mower with Kubota D902 engine that suddenly won't start at low throttle. I have always started it at the lowest throttle setting and it started just fine. Now, it simply won't start at the lowest throttle setting. I thought something was seriously wrong, and I was just...
Last Post By: Curt Harms Today, 12:00 PMJust read a post where the guy called himself an epoxy woodworker. Made me think about other combinations; steel woodworker, non ferrous metal woodworker...... Got any other ideas?
Last Post By: Edward Weber Yesterday, 3:47 PMI've seen threads discussing the pros and cons of straight-sided versus bevel-sided mortise chisels. The big takeaways seem to be 1. Straight sides encourage a straight mortise with less chance of side-to-side wander 2. Chisels with angled sides are easier to extract after a chop and aren't so...
Last Post By: Cameron Wood Yesterday, 11:11 PMThis thread has no redeeming value. You have been warned. Got an ECE block plane here recently. Solely out of curiosity went I looking around, and found LV carries ECE planes, but not this one, but they do have replacement blades for it - which I will never need. Even so - I was pondering...
Last Post By: steven c newman Yesterday, 3:54 PMBeen doing it like (or equivalent) this for years. (Votes: 4)
Wow! Never thought of that. (Votes: 0)
Been doing it with mirrors. (Votes: 2)
Ain't got a boat, truck, care… (Votes: 0)
Yes, you will need to attach temporary gluing ears, curved on the inside to match your parts with a squared off end for clamp pads at right angles to
Kevin Jenness Today, 12:51 PMI thought safety tooth blades might not work. NOt enough room to jam the stop in between the teeth. I mean then kind where the tooth has a depth limiter
Bill Dufour Today, 12:49 PMNice!
Very nice. (added to meet the minimum required words..)
I use my Dust Deputy/Rigid shop vac for both hand held tools and general cleanup in my two car garage shop. I have a 20ft hose from Lee Valley and a set
Doug Garson Today, 12:46 PMAlan, I completed my chairs. Here's how the shaping of the backs turned out - hopefully a little inspiration ...
More photos
Time for some levity
Thread Starter: Dave Anderson NHWith all of the negativity and political stuff going on with the Covid-19 virus it is time to look at the humorous side of things. Feel free to add more, but keep it clean or it will be deleted.
Last Post By: Jim Allen Yesterday, 3:16 PM