Lord, give me patience and understanding for those folks that drive needlessly in the left lane. Amen
Last Post By: Jim Koepke Today, 2:23 PMHas been restocked.. Bought 10 planks...for $30...had to cut a few of the 10 footers down, to fit into the Trunk of my Chevy Equinox... Eight 1 x 6 x 6' Five 1 x 4 x 6' And he threw in a stack of shorts And a 3/4" x 8" x 39" slab..
Last Post By: steven c newman Today, 4:57 PMSaw this today while reading a story about the prospect of electrical distribution networks failing due to heat: When I mentioned to Candy that transformers don't "slow down" high voltage, but "step down" high-voltage to a lower voltage, she said, "it's just semantics." Though it seems...
Last Post By: Rob Luter Today, 4:10 PMI'm volunteering for a food bank and trying to set up a cold room to store produce and other perishables. The main cooling will be done by a pair of air conditioners controlled by a Coolbot which enables the air conditioners to cool the room down below the usual lower limit for air conditioners...
Last Post By: Malcolm McLeod Today, 8:22 AMOne of those sitting at the computer in the morning with a cup of coffee itching to buy a new tool ... So I come across this Veritas Scraper Burnisher for Turners and looked at a few videos reviews of it and thought why not. After reading a few reviews posted on this forum I later realized it was...
Last Post By: Rich Engelhardt Today, 12:46 PMBeen doing it like (or equivalent) this for years. (Votes: 4)
Wow! Never thought of that. (Votes: 0)
Been doing it with mirrors. (Votes: 2)
Ain't got a boat, truck, care… (Votes: 0)
lol
Neighbors said ok. ! great people.
I do not know of any lifting points at this time. I have a engine hoist.
One has not lived
I made a flashing that went under the drip edge into the eves. Put on before the eve hangers. All water goes into the flashing int the eves, it will
Warren Lake Today, 8:55 PMAnywhere you have a seam in a gutter, place a piece of flashing material over the facia board to prevent rot. Let it hang down below facia board by about
Bruce Wrenn Today, 8:29 PMI had a Lee Valley version in my shop for a while. It’s extremely fussy to set up.
Rob Luter Today, 8:21 PMSo both the Baldor and Leeson motors have the same problem? Seems unlikely the issue is the motor, then.
When you say you measured the ohms,
Time for some levity
Thread Starter: Dave Anderson NHWith all of the negativity and political stuff going on with the Covid-19 virus it is time to look at the humorous side of things. Feel free to add more, but keep it clean or it will be deleted.
Last Post By: Jim Allen Today, 4:47 PM