I love making windows and doors in my free time, this is my hobby. I eventually want to do timber framing too. A shaper is an important part of making the above, and I want to upgrade. Background: My current machine is a Jet JWS-25CS (3HP, up to 3/4 spindle) I need support for a 1 1/4''...
Last Post By: John Pendery Today, 4:27 PMI need to pick up some more clamps in the 36 inch range. I figured I’d see if anybody had any value options that work well. I have some Bessy and Jorge now but just trying to save a couple bucks.
Last Post By: Tom Bender Today, 8:09 AMSeems like questions about Minimax bandsaws have been popping up and I wondered if there could be an opportunity to condense knowledge into and level-set some best-practices for setup? First, any contemporary Italian or large Austrian bandsaw ought be very straightforward to set up and get cutting...
Last Post By: Brandon Luster Today, 2:44 PMIn a Master ( and only) Bathroom in the house...where all the wood cabinets are real wood...with raised panel doors.....these are to be changed over next.. Butt jointed corners, surrounding flat, plywood panels...20 coats+ of white paint ( Lead?) was supposed to be 4 doors here, until someone...
Last Post By: steven c newman Today, 4:02 PMLooking for router table. A couple projects I would like to do call for a lot of simple molding. I am a hobby woodworker partial to hand tools but use machines. I am a slow builder. My moldings have been with wooden molding planes, hand planes and scratch stock. I just picked up a Bosch router....
Last Post By: Rene Shekerjian Today, 5:15 PMUntil it is falling apart and things fall out. (Votes: 35)
Until someone gives me a new on as a gift. (Votes: 5)
Whenever I feel like it. (Votes: 5)
I have many wallets and rotate them. (Votes: 0)
Don't carry a wallet. (Votes: 2)
I use a money clip instead. (Votes: 1)
I typically use brake cleaner because it works well and I usually have a can of it in my shop.
Pat Germain Today, 5:19 PMYou may already know this, but you'll need to make sure the motor/impeller is spinning the correct direction. If it is turning in the wrong direction,
Aaron Inami Today, 5:17 PMI have the same router in a Bosch router table. Adjusting from above the table works reasonably well, as long as you have the screw head of the height
Rene Shekerjian Today, 5:15 PMMy shop is 16' wide, but the line that runs to the Jointer/Planer is probably close to 25' given all the turns in there. The line to the back of the
Steve Wurster Today, 5:10 PMMore space between the building and the retaining wall is better.
Tom M King Today, 5:03 PM
Time for some levity
Thread Starter: Dave Anderson NHWith all of the negativity and political stuff going on with the Covid-19 virus it is time to look at the humorous side of things. Feel free to add more, but keep it clean or it will be deleted.
Last Post By: Dave Anderson NH Today, 9:37 AM