I love making windows and doors in my free time, this is my hobby. I eventually want to do timber framing too. A shaper is an important part of making the above, and I want to upgrade. Background: My current machine is a Jet JWS-25CS (3HP, up to 3/4 spindle) I need support for a 1 1/4''...
Last Post By: Brian Holcombe Today, 3:59 PMIn a Master ( and only) Bathroom in the house...where all the wood cabinets are real wood...with raised panel doors.....these are to be changed over next.. Butt jointed corners, surrounding flat, plywood panels...20 coats+ of white paint ( Lead?) was supposed to be 4 doors here, until someone...
Last Post By: steven c newman Today, 7:04 PMSomething in one of the other handplane posts got me thinking about a subject that has puzzled me. Rigorous experiments by industry and the NFPL show that the best glue joint is between 2 matching smoothly knife planed surfaces. This includes hot hide glue; maybe excepting epoxy. Yet since...
Last Post By: Mark Leifer Today, 5:55 PMWe have the Ryobi ONE+ 18v battery system so I'd like to stay with that. Looking at the reciprocating saw for trimming branches and possibly shop work. Getting older and trying to not buy any more tools but at $58 it doesn't make a big dent in the plan. Will it chew thru 3" limbs?
Last Post By: Ed Aumiller Today, 12:36 PMLooking for router table. A couple projects I would like to do call for a lot of simple molding. I am a hobby woodworker partial to hand tools but use machines. I am a slow builder. My moldings have been with wooden molding planes, hand planes and scratch stock. I just picked up a Bosch router....
Last Post By: Bob Jones 5443 Today, 3:22 PMUntil it is falling apart and things fall out. (Votes: 35)
Until someone gives me a new on as a gift. (Votes: 5)
Whenever I feel like it. (Votes: 5)
I have many wallets and rotate them. (Votes: 0)
Don't carry a wallet. (Votes: 2)
I use a money clip instead. (Votes: 1)
Hi, looking for some advice.
Bought a pallet of stuff at an auction.
Couple tools I can use, and a Max Model 0VS Ser # 9312 Spindle Sander.
Ok...there is a hinge issue with the existing doors..amongst other problems...
There is a piece of trim...1 x 4 x 8' runs floor to ceiling...and
I laminated two layers for my 3-1/2' x 6' MFT table. I had a whole bunch of clamps and cross-boards. I had a buddy help me with the glue up. I used
Aaron Inami Today, 6:46 PMI have used both Felder and Minimax sliders. Both are good machines, but personally, I like the Felder sliding table saws better (if you get a K700 machine
Aaron Inami Today, 6:34 PM
Time for some levity
Thread Starter: Dave Anderson NHWith all of the negativity and political stuff going on with the Covid-19 virus it is time to look at the humorous side of things. Feel free to add more, but keep it clean or it will be deleted.
Last Post By: Jim Allen Today, 3:31 PM