Has been restocked.. Bought 10 planks...for $30...had to cut a few of the 10 footers down, to fit into the Trunk of my Chevy Equinox... Eight 1 x 6 x 6' Five 1 x 4 x 6' And he threw in a stack of shorts And a 3/4" x 8" x 39" slab..
Last Post By: steven c newman Yesterday, 12:56 PMHad a 7.5 baldor, had a seperate post on this because I thought I figured out what was going on but evidently this is beyond my knowledge or experience. I replaced caps on 7.5 baldor, no difference, bought new leeson 7.5 hp, both single phase motors, got it hooked up, check wiring, cranked...
Last Post By: Rob Luter Today, 7:08 AMOne of those sitting at the computer in the morning with a cup of coffee itching to buy a new tool ... So I come across this Veritas Scraper Burnisher for Turners and looked at a few videos reviews of it and thought why not. After reading a few reviews posted on this forum I later realized it was...
Last Post By: stephen thomas Yesterday, 1:46 PMMy router on the recently purchased router table quit, it came on then off then on now it will not come on. I have it pulled apart trying to get all the sawdust out of the connections, it's embedded pretty bad, not sure if that is the cause but worth a try. I found another identical one on eBay for...
Last Post By: chris hood Today, 7:51 AMI'm pondering the economics of a mill vs buying rough lumber at retail/wholesale. In the Bay Area, depending on where you shop hardwoods like Oak and walnut can run up to $15-18bf/ft, or more for the rift/quarter sawn stuff. If one is able to source your own logs, running your own mil and kiln...
Last Post By: Rod Sheridan Yesterday, 8:29 PMBeen doing it like (or equivalent) this for years. (Votes: 4)
Wow! Never thought of that. (Votes: 0)
Been doing it with mirrors. (Votes: 2)
Ain't got a boat, truck, care… (Votes: 0)
1) Accurate polling is a very difficult and expensive proposition. The primary issue is ensuring that the sample is representative, as many have said
roger wiegand Today, 8:21 AMIve only used the premixed GF brand milk paint. With some colors i would need a second pass. And these streaks go away. Im pretty sure thats what you
George Yetka Today, 8:21 AMFor sale: Festool Domino DF500 with Tenons and Bits
Lightly used Festool Domino DF500 set with tenon systainer and bits. The entire set
Looks great
Tom Bender Today, 8:09 AM
Dining room carver chairs - Take 2
Thread Starter: Derek CohenAbout a month ago I began a thread about designing and building two carver chairs to accompany the 6 bentwood chairs we have owned for the past 40 years. The chairs were purchased all those years ago along with a table, which is around 200 years old. We need a larger table, and time has come to...
Last Post By: Derek Cohen Today, 6:12 AM