• Recent Articles

  • Hottest Threads

    Erich Weidner

    Squaring Up Really Long Boards... Tips?

    Thread Starter: Erich Weidner

    I have a few dozen long boards I need to glue up into large panels. (11' to 16' for each section). They will be about 32" wide. I'm gluing up from 1 x 6 S4S stock. (So nominally 3/4" x 5-1/2"). They of course all have some bow, cup, or twist. I don't care at all about the look of one flat face...

    Last Post By: Erich Weidner Yesterday, 11:41 PM Go to last post
    steven c newman

    A new Desk for me

    Thread Starter: steven c newman

    "old" one is cramped, small drawers....not enough room for the computer I am using...so. Came up with a rough "Plan".. Picked up about 40bf of Ash....($20.....) Then drew up a better Plan... More as a guide, than anything carved in stone....(already a few design changes have been made..)...

    Last Post By: steven c newman Yesterday, 9:55 PM Go to last post
    Ole Anderson

    Craftsman at Lowe's and Ace

    Thread Starter: Ole Anderson

    Anybody else get the tinglies now when walking into Lowe's and seeing row on top of row of red Craftsman tools, chests and equipment? Not that I am such a fan of their stuff, just that it brings back good memories of trolling through the Sears tool department years ago. Even my local Ace carries...

    Last Post By: Ronald Blue Yesterday, 7:06 PM Go to last post
    lowell holmes

    Tool rust prevention

    Thread Starter: lowell holmes

    In the current issue of This Old House Magazine, a reader ask Tom Silva how he prevents rust on his tools. I live in Galveston County Texas, so I Know a bit about rust. I coat my tools with Johnson's Floor Wax. They do not rust. I thought some new woodworkers might be interested.

    Last Post By: Jacob Mac Yesterday, 9:11 PM Go to last post
    Alan Lightstone

    Soundproofing for workshop entry wall

    Thread Starter: Alan Lightstone

    Finally getting a contractor to put the walls up in my workshop. I've been looking at a variety of techniques for soundproofing the walls (it's an interior wall to my garage, the exterior walls are cinderblock and aren't being done now. There will be a double outside rated entry door from the...

    Last Post By: Frank Pratt Today, 2:52 AM Go to last post
    Bram de Jong

    Moxon vise design "review"?

    Thread Starter: Bram de Jong

    Hi everyone, Since a while I've been slowly working on a "fully parametric" version of a Moxon vise design in Fusion 360. Fully parametric meaning you can change all the sizes of width, height, thread diameter etc etc with the model still working. But I'd like some review of the model itself...

    Last Post By: Tom Bussey Today, 8:29 AM Go to last post