I love making windows and doors in my free time, this is my hobby. I eventually want to do timber framing too. A shaper is an important part of making the above, and I want to upgrade. Background: My current machine is a Jet JWS-25CS (3HP, up to 3/4 spindle) I need support for a 1 1/4''...
Last Post By: Warren Lake Yesterday, 2:37 PMI need to pick up some more clamps in the 36 inch range. I figured I’d see if anybody had any value options that work well. I have some Bessy and Jorge now but just trying to save a couple bucks.
Last Post By: David Walser Yesterday, 11:08 PMSeems like questions about Minimax bandsaws have been popping up and I wondered if there could be an opportunity to condense knowledge into and level-set some best-practices for setup? First, any contemporary Italian or large Austrian bandsaw ought be very straightforward to set up and get cutting...
Last Post By: Chris Parks Yesterday, 7:22 PMLooking for router table. A couple projects I would like to do call for a lot of simple molding. I am a hobby woodworker partial to hand tools but use machines. I am a slow builder. My moldings have been with wooden molding planes, hand planes and scratch stock. I just picked up a Bosch router....
Last Post By: Warren Lake Yesterday, 12:38 PMIn a Master ( and only) Bathroom in the house...where all the wood cabinets are real wood...with raised panel doors.....these are to be changed over next.. Butt jointed corners, surrounding flat, plywood panels...20 coats+ of white paint ( Lead?) was supposed to be 4 doors here, until someone...
Last Post By: steven c newman Yesterday, 4:20 PMUntil it is falling apart and things fall out. (Votes: 35)
Until someone gives me a new on as a gift. (Votes: 5)
Whenever I feel like it. (Votes: 5)
I have many wallets and rotate them. (Votes: 0)
Don't carry a wallet. (Votes: 2)
I use a money clip instead. (Votes: 1)
Be careful how low you go in the grit with which you start. Low grits, as Cameron notes, do most of the work. This is the level at which problems are
Derek Cohen Today, 2:29 AMthanks Rich, havent listened to them for a while but it was very good work. Stuck doing tax stuff ill put it on.
first two boards are dirty
I picked up some Ryobi bits like you want, I cannot find them now though. I did find these on Amazon Owl Tools 24 Pack of Hex Head Allen Wrench Drill
Dan Rude Today, 1:45 AMBingo! You have to pay close attention on that page!
Ken Fitzgerald Today, 1:43 AMI'm guessing you went to Bikes, Blues, and BBQ? A little warm but great weather for a ride!
Working the Grain Hardwoods in Bentonville
Time for some levity
Thread Starter: Dave Anderson NHWith all of the negativity and political stuff going on with the Covid-19 virus it is time to look at the humorous side of things. Feel free to add more, but keep it clean or it will be deleted.
Last Post By: Jim Allen Yesterday, 5:27 PM