OK, let's see if this gets legs. Some time ago I asked (in the Forum Tech Support forum which apparently almost no one reads) if we could have a separate forum dedicated to workshop tips and tricks. Well that didn't go anywhere, so why not just have a thread dedicated to your ideas around the...
Last Post By: Doug Garson Yesterday, 6:53 PMAm I the jerk here? Sorry for the length… I’d like to share my peculiar experience with a well-respected tookmaker/distributor within the community. First and foremost, I have nothing but respect for Rob Cosman. I’ve purchased numerous products from him, and they’ve all been great, but I’m at...
Last Post By: Mike Brady Today, 11:36 AMI need to pick up some more clamps in the 36 inch range. I figured I’d see if anybody had any value options that work well. I have some Bessy and Jorge now but just trying to save a couple bucks.
Last Post By: Robert Engel Today, 6:19 AMIn a Master ( and only) Bathroom in the house...where all the wood cabinets are real wood...with raised panel doors.....these are to be changed over next.. Butt jointed corners, surrounding flat, plywood panels...20 coats+ of white paint ( Lead?) was supposed to be 4 doors here, until someone...
Last Post By: steven c newman Today, 1:57 PMI"ve never seen anything like it. During the 33 years that I built spec houses on the lake, I saw a few recessions and built a smaller house those years. It was always a mistake as I could just as easily built a big house and still sold it. Land value has always gone up. I'd buy a lot one...
Last Post By: Dave Anderson NH Today, 4:04 PMUntil it is falling apart and things fall out. (Votes: 36)
Until someone gives me a new on as a gift. (Votes: 5)
Whenever I feel like it. (Votes: 5)
I have many wallets and rotate them. (Votes: 0)
Don't carry a wallet. (Votes: 2)
I use a money clip instead. (Votes: 1)
zero chance I could work on six the 8 general was okay for all my work till I tried the SCM. I could have made a living on general though one job was
Warren Lake Today, 4:27 PMI've done that more tmies than I care to remember, if I could remember.
It really ony happens when I get interrupted during a project and
Excellent info, all - thank you!
These are clad casements. I'm hesitant to do "replacements" as I don't want to lose even a little
Years ago I asked about buying a jointer here on SMC. Almost everyone said, "Get an eight inch if at all possible". So I did. Boy was that good
Pat Germain Today, 4:18 PMA few weeks back I made a Gnocchi board for Mary. Smallish, paddle shaped board with grooves on it to give gnocchi their characteristic texture. $10
Paul F Franklin Today, 4:05 PM
Time for some levity
Thread Starter: Dave Anderson NHWith all of the negativity and political stuff going on with the Covid-19 virus it is time to look at the humorous side of things. Feel free to add more, but keep it clean or it will be deleted.
Last Post By: Dave Anderson NH Today, 10:11 AM