• Recent Articles

  • Hottest Threads

    Patrick Walsh

    Vintage Martin T75 restoration

    Thread Starter: Patrick Walsh

    So I have a opportunity to purchase the above machine for a fair deal from my employer. I am aware of the phenolic guides being pop riveted I the the sliding table along with not availible for replacement. So my question is as follows to those in the know with regard to the phenolic ways....

    Last Post By: Patrick Walsh Yesterday, 8:56 PM Go to last post
    Chris Kalnasy

    8" Jointer Options

    Thread Starter: Chris Kalnasy

    So I have scoured thread after thread regarding 8" jointers. Right now I am landing with the Grizzly G0858 Parallelogram Helical head. Is there anything else in that price range that far surpasses the grizzly unit? And yes I am shopping new as to have a warranty with it unless it was some...

    Last Post By: Tim Cardinal Today, 2:28 PM Go to last post
    Allan Speers

    Is a 1.5 HP cyclone enough for my gargage shop?

    Thread Starter: Allan Speers

    I know this has been asked many, many times, but I'm hoping for opinions on my specific setup: I have a typical hobbyist 2-car garage-shop. I only use 1 machine at a time. My biggest chip producer is a 12", 3 HP Powermatic 100 planer. I also have a 3 HP Unisaw and a 21", 5 HP bandsaw, but...

    Last Post By: Jim Becker Today, 7:21 PM Go to last post
    steven c newman

    Box Project, from scraps of Ash

    Thread Starter: steven c newman

    Well, will see how this goes....already have had a few days start. Had a tall stack of resawn Ash, before all those trips to the Hospitals happened, and then the Chester Drawers Project....decided to clear the "decks" and see what I could build with the stuff...Sorted through, found 4 pieces...

    Last Post By: steven c newman Yesterday, 9:35 PM Go to last post
    Marshall Harrison

    Which Miter Gauge to Choose?

    Thread Starter: Marshall Harrison

    I'm looking to get a better miter gauge for my table saw and I can't decide between the Kreg Miter Gauge System or the Incra 1000 SE. If you have one of these I would love to hear your impression of it and why you chose it. Both look like they are well made and would do the job. So what say you...

    Last Post By: Prashun Patel Today, 12:59 PM Go to last post
    Dan Gaylin

    Band saw blade size and burning

    Thread Starter: Dan Gaylin

    Hi all, i finally bit the bullet and got a new bandsaw, Jet JBS-14SFX. I am generally very happy with it but I have two questions: First the saw seems to burn hardwood of 2-3 thick. I’ve tried different feed rates but it seems to consistently cause some burning. Any thoughts about why this...

    Last Post By: Chapel Eastland Today, 5:11 PM Go to last post