Fed up with Nambi Pambi safe for the environment stuff and have been for a long time. I have weeds and other things growing around and behind my shed and else where, I just want it All Gone. I can buy the Ortho Ground Clear and it takes 24 Oz of the stuff to a gallon of water and the jug is $42...
Last Post By: Bill Dufour Today, 8:08 PMI'm building an exterior entry door. Entry area is covered and gets very little sunlight or weather, so this shouldn't be too challenging. I like the attached pic, but am unsure how to construct it. Setting aside the window for a second, my plan was to make the rails and stiles from 1.75"...
Last Post By: John TenEyck Today, 3:02 PMI am in the process of planning out a trestle dining table. The design is essentially done, but I am having thoughts about the sizing/thickness of the parts. The base is to be Jarrah, which is a particularly hard and stiff wood (from Western Australia, if you are unfamiliar with it). I have...
Last Post By: Cameron Wood Yesterday, 9:45 PMI searched the forum and couldnt find a specific answer to this question other than people debating the idea. I am in the middle of a sapele door build, and i need about 30 14mmx6" dominoes. I only have the 14mmx75mm domino stock, so i need to buy the uncut sticks or make my own. $95 solves that...
Last Post By: Rich Engelhardt Today, 7:32 AMLet me start by saying that I love, own and hold Lee Valley products in the highest regard. Their medium shoulder plane is perhaps one of the best tools I have ever owned, beautiful. As an engineer I appreciate all the thought that goes into their designs, which are so well executed. I have 3 of...
Last Post By: Patrick C Daugherty Today, 8:31 PMThis place seems to have chucks to fit a few different sizes/models of the yankee; might not be the one I linked to but they have other sizes according
Paul F Franklin Today, 9:03 PMI have one of these Makita chucks with hex shank. You could buy the adapter for the hex bits and then use this in the adapter instead of a hex bit.
David Buchhauser Today, 8:48 PMI can't for the life of me see why one would spend a lot of time and effort trying to mitigate the poor performance of expensive premium chisels. Send
Patrick C Daugherty Today, 8:31 PMDoes anyone know of a way to add a 3 or 4 jaw chuck to a Yankee Handyman push drill? I've seen adapters for hex bits but not one that would work for
Jonathan Roberts Today, 8:27 PMHey John, its still available. Sent you a PM.
Keegan Shields Today, 8:19 PM
Time for some levity
Thread Starter: Dave Anderson NHWith all of the negativity and political stuff going on with the Covid-19 virus it is time to look at the humorous side of things. Feel free to add more, but keep it clean or it will be deleted.
Last Post By: Jim Allen Today, 4:02 PM