• Recent Polls

    Is this thread worth it's contents? (Votes: 2)

    1. yes (Votes: 1)

    2. no (Votes: 0)

    3. helpful (Votes: 0)

    4. not enough info. (Votes: 0)

    5. pictures are good evidence (Votes: 0)

    6. Thread is a good info. (Votes: 1)

  • Recent Forum Posts

    Steve Eure

    Prepping New Lathe

    WD-40 has a dry silicon lubricant that works well. That's what I used on my 18-36. The Laguga lathes have steel beds instead of cast iron, but will

    Steve Eure Today, 7:08 AM Go to last post
    Bradley Gray

    Uncooperative Wood

    I think the oven test is a good idea to get the actual MC but no doubt the wood is still drying.

    It is important to allow air to reach both

    Bradley Gray Today, 7:04 AM Go to last post
    Steve Fish

    Buyer's remorse on Metabo HPT 10" Slider?

    [QUOTE. “I'm not sure how these have changed over time, “but my guess is that it's still a solid saw.[/QUOTE]
    I think The first saws were made in

    Steve Fish Today, 6:50 AM Go to last post
    Tim Otto

    Powermatic model 180 planer

    I have it torn down, got the sectional chip breaker segments on order, shelix on order, but have run into a new problem: one of the 4 coil compression

    Tim Otto Today, 6:50 AM Go to last post
    Rob Luter

    new garage door worth it?

    I replaced a set of old wood (MDF) doors with insulated fiberglass. It made a big difference. In addition to being well insulated, they seal very well

    Rob Luter Today, 6:45 AM Go to last post