• Recent Articles

  • Recent Article Comments Widget

    Bob Bollard

    Using CA Glue in Woodturning

    The fumes are bothersome. Is it safe to use a dust extractor to suck the fumes away? Or would the... Go to last post

    Bob Bollard 03-14-2019 12:07 PM
  • Hottest Threads

    Patrick Walsh

    Vintage Martin T75 restoration

    Thread Starter: Patrick Walsh

    So I have a opportunity to purchase the above machine for a fair deal from my employer. I am aware of the phenolic guides being pop riveted I the the sliding table along with not availible for replacement. So my question is as follows to those in the know with regard to the phenolic ways....

    Last Post By: Patrick Walsh Yesterday, 11:10 PM Go to last post
    Jefferey Scott

    Oklahoma Homestead 40x80x12

    Thread Starter: Jefferey Scott

    Hey guys, I'm in the early planning stages for a workshop that will be used as both a woodworking shop and a metal fabrication shop. I'm trying to figure out how much lighting I can afford to put in and have a rough floorplan with 21 - 4 foot 4 bulb high bay fluorescent fixtures (at about $60 a...

    Last Post By: Jefferey Scott Today, 7:31 AM Go to last post
    Kris Cook

    New Shop Construction

    Thread Starter: Kris Cook

    I currently have my shop in a two-car garage. While I don't necessarily use both bays of the garage solely for wood working; for me the footprint of one bay is not adequate space to efficiently work. We are down-sizing and have just purchased a 100-year old house north of where we live now. The...

    Last Post By: Kris Cook Yesterday, 9:03 PM Go to last post
    Bruce Day

    Two foolish mistakes at table saw cost me, dearly - Graphic Photos!

    Thread Starter: Bruce Day

    Not very long ago I was at the table saw trimming the last of four legs of a table I was building. I had turned the saw off for a second to clean some debris off then got ready to do the last one, when I made the mistake of using a push stick instead of my gripper or push block. After I got about...

    Last Post By: Simon MacGowen Yesterday, 11:40 PM Go to last post
    Ellen Benkin

    Storing clamps

    Thread Starter: Ellen Benkin

    I have an ever growing collection of clamps which has outgrown the storage system I built for them years ago. I currently store them on a wall and want to continue doing that since floor space in my garage is at a premium. I recently got an email from Woodpeckers for their new clamp "rack-it"...

    Last Post By: Paul Wunder Today, 8:24 AM Go to last post
    David Ruhland

    How do i match a radius?

    Thread Starter: David Ruhland

    I am trying to figure out how to match the radius of the truck box so the board slides down inside and fits tightly to the bed. Thoughts/Suggestions please Thanks...

    Last Post By: Phillip Mitchell Yesterday, 3:52 PM Go to last post