Looking for a new project to do. I've been spending a few months upgrading the workshop / fixing minor annoyances, and really need to actually build something. I ran across this in a magazine ad. The furniture is supposedly solid teak, though I don't think that will be in the cards for...
Last Post By: Kevin Jenness Today, 10:07 AMI have a 2019 Grasshopper mower with Kubota D902 engine that suddenly won't start at low throttle. I have always started it at the lowest throttle setting and it started just fine. Now, it simply won't start at the lowest throttle setting. I thought something was seriously wrong, and I was just...
Last Post By: Brian Elfert Today, 2:15 PMJust read a post where the guy called himself an epoxy woodworker. Made me think about other combinations; steel woodworker, non ferrous metal woodworker...... Got any other ideas?
Last Post By: Maurice Mcmurry Today, 7:54 PMThis thread has no redeeming value. You have been warned. Got an ECE block plane here recently. Solely out of curiosity went I looking around, and found LV carries ECE planes, but not this one, but they do have replacement blades for it - which I will never need. Even so - I was pondering...
Last Post By: Rafael Herrera Today, 1:38 PMI didn't want to kidnap Kent's thread so I started this one. Born in the late '40s, I feel blessed to have lived in the 50s, 60s and 70s to experience the musical buffet of the time. From 50s style country music, the folk music era, the Rockibilly era, Motown, the British Invasion and into 70s...
Last Post By: Alan Lightstone Today, 8:31 AMBeen doing it like (or equivalent) this for years. (Votes: 4)
Wow! Never thought of that. (Votes: 0)
Been doing it with mirrors. (Votes: 2)
Ain't got a boat, truck, care… (Votes: 0)
I don't understand what the clamp was doing- moral support? Or the speed square for that matter...
Maybe it was meant to be a spoof?
I used to have that jointer and had the same problem. If you can take the pressure off the screws, you might be able to turn them then. Find a flat piece
Ken Platt Today, 10:25 PMHi, thanks for the reply Joe. I know I am turning the correct direction because the other 2 bolts loosened up that way on the blade. At first I was
mark ahlenius Today, 9:07 PMWhen I was in employment the shop used a shirtload of paperbacked veneer sheets. We had one project, a 12' maple conference table, that developed hundreds
Kevin Jenness Today, 9:04 PMJust a chuckle for a Friday evening > https://www.facebook.com/reel/443287808419980
jtk
Time for some levity
Thread Starter: Dave Anderson NHWith all of the negativity and political stuff going on with the Covid-19 virus it is time to look at the humorous side of things. Feel free to add more, but keep it clean or it will be deleted.
Last Post By: Jim Allen Today, 5:32 PM