I love making windows and doors in my free time, this is my hobby. I eventually want to do timber framing too. A shaper is an important part of making the above, and I want to upgrade. Background: My current machine is a Jet JWS-25CS (3HP, up to 3/4 spindle) I need support for a 1 1/4''...
Last Post By: Warren Lake Today, 2:37 PMSeems like questions about Minimax bandsaws have been popping up and I wondered if there could be an opportunity to condense knowledge into and level-set some best-practices for setup? First, any contemporary Italian or large Austrian bandsaw ought be very straightforward to set up and get cutting...
Last Post By: Chris Parks Today, 7:22 PMLooking for router table. A couple projects I would like to do call for a lot of simple molding. I am a hobby woodworker partial to hand tools but use machines. I am a slow builder. My moldings have been with wooden molding planes, hand planes and scratch stock. I just picked up a Bosch router....
Last Post By: Warren Lake Today, 12:38 PMIn a Master ( and only) Bathroom in the house...where all the wood cabinets are real wood...with raised panel doors.....these are to be changed over next.. Butt jointed corners, surrounding flat, plywood panels...20 coats+ of white paint ( Lead?) was supposed to be 4 doors here, until someone...
Last Post By: steven c newman Today, 4:20 PMWith apologies for yet another slider thread, but (like everyone else) I want to make sure I'm making the best decision here. I'm looking for a slider for my new workshop (which will be ready in November). I mostly work with hardwood furniture (lots of handwork), but do sometimes work in panels...
Last Post By: Warren Lake Today, 5:29 PMUntil it is falling apart and things fall out. (Votes: 35)
Until someone gives me a new on as a gift. (Votes: 5)
Whenever I feel like it. (Votes: 5)
I have many wallets and rotate them. (Votes: 0)
Don't carry a wallet. (Votes: 2)
I use a money clip instead. (Votes: 1)
EZ Wings looks nice (but pricy), but what kind of turns me off some is they design a good system and then don't even have a good stop set up for there
richard poitras Today, 10:06 PMThere are different kinds of brake clean. Some are tetrachloroethylene, acetone, heptane and isopropyl based.
Nathan Sampson Today, 9:58 PMIt doesn't set long on anything. It's so little in the spray cans that I use it sparingly anyway. I used some a few days ago on some old trailer hubs
Tom M King Today, 9:43 PMIt’s 1840 here in CA and I haven’t seen it yet. You did say USPS. Met the mailman today. Didn’t have it.
Wayne Nicholson Today, 9:42 PMI run ethanol gas in my generators. Rotate fuel out four times per year, and run it in vehicles. Always shut down generator by shutting of fuel, and
Bruce Wrenn Today, 9:30 PM
Time for some levity
Thread Starter: Dave Anderson NHWith all of the negativity and political stuff going on with the Covid-19 virus it is time to look at the humorous side of things. Feel free to add more, but keep it clean or it will be deleted.
Last Post By: Jim Allen Today, 5:27 PM