So I have a opportunity to purchase the above machine for a fair deal from my employer. I am aware of the phenolic guides being pop riveted I the the sliding table along with not availible for replacement. So my question is as follows to those in the know with regard to the phenolic ways....
Last Post By: joe milana Today, 9:57 PMHave any of you been a print subscriber and then added "online membership"? I've been with them since 1980 and can't store all of the magazines. I end up just going to FWW and searching for the article that I want and I'm done. SO, I need to understand what the "Ultimate" is all about because...
Last Post By: Thomas McCurnin Yesterday, 11:01 PMHey Creekers, I hope this isn't a stupid question. I will be trying to organize my workshop over I'd like your thoughts on workshop storage. What are your thoughts on shelves, vs cabinets? Pegboard? Other?
Last Post By: Günter VögelBerg Today, 1:57 PMMy 19 year old Troy-Bilt snow blower is dead. A bearing support for the auger broke and no longer available. This was one of the last units made before Gardenway went bankrupt. This is not an MTD. This thing is a tank. It broke a few years back and the hardware store I bought it from said to...
Last Post By: Brian Elfert Today, 1:21 PMWell, I've seriously looked at my finances and it has reflected that I am not going to be able to pay cash for a Stinger II or even a Stinger I CNC setup. So, I'm now looking at the Shapeoko 3 XXL to allow me to get experience with CNC and enable me to do a few things that I could surely use in my...
Last Post By: David Buchhauser Today, 12:23 AMWell I use to shave everyday and get my blades from an online shave club. Over the last year or so since I don't get out as much I find I don't shave everyday sometimes I let it got for 2 or 3 days. Then I find my dbl blade razors don't do the job they get clogged up pretty quick and hard to rinse...
Last Post By: Dave Lehnert Today, 9:24 PMYES (Votes: 12)
NO (Votes: 29)
Perfeckta moulding head by freud USA carbide 1.25 bore will cut 39 different designs by using the enclosed template
in perfect condition asking180.00
Something like that i rough turn to 3/4 inch then coat in anchor seal and let it sit for 4 months or so. 18% is not super wet some fresh cut pieces i
Chris A Lawrence Today, 10:00 PMWell rather than investing in a kapex with stand and wings to try to get precision trim (which I don’t have room for anyway), and rather than always
Greg Parrish Today, 9:59 PMOn you shimming the outrigger undercarriage, it is really best to shim the table. Every adjustment can be made on the carriage except rotational. That
joe milana Today, 9:57 PM
vBulletin Message