With all of the negativity and political stuff going on with the Covid-19 virus it is time to look at the humorous side of things. Feel free to add more, but keep it clean or it will be deleted.
Last Post By: John Ziebron Yesterday, 4:44 PMEarlier this week, went to local grocery to buy some sweet potatoes, which were on sale for $0.25 per pound. They come, 40# to the box, and I wanted 4 boxes (160#.) We like sweet potatoes, and these $0.25 per pound ones taste a lot better than the $1.19 per pound ones. Being as how they were in...
Last Post By: Mike Soaper Today, 9:16 AM- 4 in one screwdrivers. Probably 1/2 of use of screwdrivers is prying, wedging, poking, etc., and these fail miserably at this. Add the bits getting stuck and lost- junk. - Quick grip clamps. Almost every one I have used did not hold, and at best had miserable clamping pressure. A scam. -...
Last Post By: Rich Engelhardt Today, 8:54 AMStill working on the 7’ table top. Planing the edges of the last panel to put on the edge. Both edges seem plat along their length to my long veritas straight edge and square side to side with my small square. When I put them together there is a gap on both sides full length that doesn’t want to...
Last Post By: Jim Koepke Yesterday, 10:33 PMSo many features on some. Anyone have experience with these things? What features do you recommend? We have old growth pine floors with area rugs and no pets. There are stairs and this will be dedicated to the upstate’s, about 1300 square feet. Self emptying at the base sounds like it would be...
Last Post By: Jim Becker Yesterday, 8:43 PMI am redoing my absolutely awful dust collection setup. Right now I have a setup with (picture at bottom): * Oneida 4/5 super dust deputy * Shop Fox 1.5hp dust collector * wynn filter I'm fixing this because this system is suuuuper bad downstream as I've consistently just hacked it every...
Last Post By: Bill Dufour Today, 12:41 AMHi all - can anyone recommend a blast gate that fits 6 inch sewer pipe well? Ideally I'd like to not reduce the 6" ID too much.
Thanks.
I have this exact sander and either the chip deflection plate or the pressure plate would get slightly off kilter causing the paper to shred. A simple
Sam Force Today, 10:21 AMAsk the product manufacturer if a sun cure will work...it does with Solarez products
Jim Becker Today, 10:13 AMNothing fancy here, but I can just see myself forgetting and running a cutter into the fasteners that hold the spoilboard down. I use nylon screws.
Steven O Smith Today, 10:06 AMSometimes tape is a good answer
Tom Bender Today, 9:29 AM
vBulletin Message