• Recent Articles

  • Hottest Threads

    Patrick Walsh

    Vintage Martin T75 restoration

    Thread Starter: Patrick Walsh

    So I have a opportunity to purchase the above machine for a fair deal from my employer. I am aware of the phenolic guides being pop riveted I the the sliding table along with not availible for replacement. So my question is as follows to those in the know with regard to the phenolic ways....

    Last Post By: Patrick Walsh Yesterday, 4:43 PM Go to last post
    Malcolm Schweizer

    I'm finally building my boat.

    Thread Starter: Malcolm Schweizer

    I lofted the station moulds for her about six years ago, but we moved to a place with less room to build a boat, so she went on hold. I have borrowed a place to build and am going to make all the bits and pieces in my shop, then assemble them in the borrowed space. This is going to be a slow...

    Last Post By: Bert Kemp Yesterday, 10:29 PM Go to last post
    Dave Anderson NH

    Time for some levity

    Thread Starter: Dave Anderson NH

    With all of the negativity and political stuff going on with the Covid-19 virus it is time to look at the humorous side of things. Feel free to add more, but keep it clean or it will be deleted.

    Last Post By: julian abram Yesterday, 10:27 PM Go to last post
    lowell holmes

    Where and when will it end . . .

    Thread Starter: lowell holmes

    According to to The Daily News, a Galveston County Texas news paper, there are 130 cases of COVID-19 cases in the county, 16 in the hospital, 31 recovered. We will be house bound for two weeks. I have a workbench drawer project with materials on hand. I will have new drawers when finished. I will...

    Last Post By: Edwin Santos Today, 11:37 AM Go to last post
    Jon Grider

    What can we learn from this

    Thread Starter: Jon Grider

    * We don't have enough reserves of PPE, and other medical necessities. * We could be overly vulnerable to bio warfare because of the above. * We don't not have imo a very coordinated or comprehensive response to these crisis between federal, state, and local agencies. * Our supply chain can...

    Last Post By: Rod Sheridan Yesterday, 1:59 PM Go to last post
    Bob Riefer

    which VFD (and what else?) needed for Delta DJ 20 jointer

    Thread Starter: Bob Riefer

    Hi! New-to-me Delta DJ 20 (37-350) 8" jointer is presently setup with a 3 phase motor, starter, and switch... which I can't power without some adjustments. It's a 1997 machine that is in great condition, and very flat tables (checked with precision straight edge and feeler gauges). Just need to...

    Last Post By: Bob Riefer Yesterday, 3:27 PM Go to last post