• Recent Articles

  • Hottest Threads

    Patrick Walsh

    1986 Altendorf F45

    Thread Starter: Patrick Walsh

    So I have a opportunity to purchase the above machine for a fair deal from my employer. I am aware of the phenolic guides being pop riveted I the the sliding table along with not availible for replacement. So my question is as follows to those in the know with regard to the phenolic ways....

    Last Post By: Martin Wasner Today, 7:20 PM Go to last post
    Eric C Stoltzfus

    Electric cars

    Thread Starter: Eric C Stoltzfus

    On Monday of Last week an automotive startup called Rivian released two new vehicles. At the LA auto show they released the R1T and the R1S. The R1T is a crew cab short bed electric pickup with some amazing specs. 0-60 in 3 seconds, and a range of over 400 miles. This is comparable to a Tesla model...

    Last Post By: Yonak Hawkins Today, 3:20 PM Go to last post
    James Pallas

    What tasks intimidate you

    Thread Starter: James Pallas

    I read lots of questions about tasks in woodworking. Recently one about mortise or tenon first. What is your biggest fear. Not the arts sort type things like carving but just general tasks. Is it curves, angles, sawing to the line, planing to the line, marking out, etc? For instance, If you cut...

    Last Post By: James Pallas Today, 12:30 PM Go to last post
    Malcolm Schweizer

    Share your stupid moments

    Thread Starter: Malcolm Schweizer

    I always say, "I love a good laugh, especially when it's on me." Here's my latest "duh moment." I spent a long time with a combination plane hand-rabbeting some pine boards for building a steam box. (Note: I do this by hand because I enjoy it and not for bravado.) All I had to do was drill the...

    Last Post By: David Utterback Today, 2:37 PM Go to last post
    Brian Holcombe

    OMGA questions

    Thread Starter: Brian Holcombe

    Looking into OMGA saws, and I'm wondering what the capability is of these saws in terms of their accuracy. Is the finished cut very precise? I'm using the Kapex now and when it is used for carpentry type work it is pretty spot on, but in heavier woods it will leave a slight convexity to the...

    Last Post By: Darcy Warner Today, 5:32 PM Go to last post
    Jason Ramey

    Looking for recommendations for, joiner,planer, bandsaw

    Thread Starter: Jason Ramey

    Hello all, I am in the market for an 18 inch bandsaw, 15or20 inch planer, and 12 inch joiner. My inclination is to go with all Powermatic as this is what I am accustomed to using in the shops Iíve managed.However.... Iím looking for recommendations for alternatives to Powermatic as I can use the...

    Last Post By: Jason Ramey Today, 7:20 PM Go to last post